Anchor AN-Mini Owner's Manual - Page 4
Browse online or download pdf Owner's Manual for Speakers Anchor AN-Mini. Anchor AN-Mini 7 pages. Audio sound system
Also for Anchor AN-Mini: Specification Sheet (1 pages), Owner's Manual (4 pages), Specification (1 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages), Owner's Manual (10 pages), Owner's Manual (12 pages)
Print Page
AN-Mini/MiniVox Lite Owners Manual
OPERATING THE WIRELESS MICROPHONE/TRANSMITTER
CHANNEL SELECTION - HANDHELD TRANSMITTER
1. Unscrew battery cover on bottom of microphone
2. Set the CHANNEL SELECTOR dial to match the channel setting
of your receiver
3. Replace battery cover and tighten firmly
CAUTION: Harmful feedback may occur when walking in front of a sound system or speaker with a wireless microphone. Always point microphone away from speakers!
Waste electrical and electronic products must not be disposed
of with household waste. Please recycle where facilities exist.
Check with your Local Authority or Retailer for recycling advice.
USING YOUR WIRELESS MICROPHONES
After you have set the transmitter channel (see above) you are ready to use your wireless microphone:
1. Body-pack transmitter users must insert
the mic
plug into the transmitter jack marked MIC
2. Turn the transmitter power switch to ON
(The red LED will flash when the mic is
turned on. If the red LED stays on,
the battery is low)
NOTE: When using dual wireless, each microphone must be set to a different channel!
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
CHANNEL SELECTION - BODY-PACK TRANSMITTER
1. The channel selection dial is located on the side of the transmitter
2. Set the CHANNEL selection dial to match the channel setting of the receiver
3. Turn the AN-Mini power switch to ON
4. The RX indicators will light (only one indicator
will light at a time) when the wireless signal is
being transmitted and received
MADE IN USA
SIX YEAR WARRANTY
4