Bosch 2 User Manual And Installation Instructions - Page 35

Browse online or download pdf User Manual And Installation Instructions for Power Tool Bosch 2. Bosch 2 48 pages. Mini blender
Also for Bosch 2: Quick Installation Manual (16 pages), Manual For Installation And Utilisation (18 pages), Original Instructions Manual (13 pages), Original Instructions Manual (22 pages), Instruction Manual (32 pages), User Manual (28 pages), User Manual And Installation Instructions (16 pages), Instruction Manual (42 pages), Operating Instructions Manual (8 pages), Instruction Manual (8 pages), Instruction Manual (12 pages), Quick Start Manual (2 pages), Quick Start Manual (9 pages), Instruction Manual And Installation Instructions (36 pages), Operating Instructions Manual (26 pages), Quick Reference Manual (2 pages), User Manual And Installation Instructions (24 pages), Instruction Manual (42 pages), Information For Use (28 pages), User Manual (40 pages), User Manual And Installation Instructions (35 pages), User Manual (24 pages)

Print Page
Bosch 2 User Manual And Installation Instructions
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:60 / -2B"
"E:30 / -10" and/or
lights up.
Cause and troubleshooting
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 14
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 31
▶
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Water level measurement system is defective.
Note: With the error message, the appliance starts a
draining process.
First wait approx. 5 minutes until the drain process
1.
ends.
To reset the error message, switch the appliance
2.
off.
Switch the appliance back on.
3.
If the error message is displayed again, call cus-
4.
tomer service.
→ "Customer Service", Page 44
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 29
▶
Water level is too high.
Troubleshooting en
35