Anchor BIG2EU Owner's Manual - Page 14

Browse online or download pdf Owner's Manual for Speaker System Anchor BIG2EU. Anchor BIG2EU 17 pages.

Print Page

HAVING TROUBLE WITH YOUR SOUND SYSTEM?

No Sound (power LED off)

No Sound (power LED on)

Shortened Battery Life

Distorted Sound

Excessive Hum or Noise • Use shielded cables

HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (WIRELESS MODELS ONLY)

No Sound (RX Indicator: ON)

No Sound (RX Indicator: OFF)

CAUTION: FEEDBACK CAN DAMAGE YOUR EQUIPMENT & MAY BE HAZARDOUS TO HEARING

Controlling Feedback

Feedback Causes

Avoiding & Eliminating Feedback

HAVING TROUBLE WITH YOUR SOUND SYSTEM?

CONDITION POSSIBLE SOLUTION

• Turn POWER switch ON

• Charge battery or plug in AC cord

• Safely shut down if unit overheats, turn volume lower & turn speaker ON

• Check for output from source

• Make sure all cables are completely plugged in

• Turn up volume control of input used

• Remove plug from speaker output if not using external speaker output

• Charge battery fully; if battery life continues to deteriorate, contact Anchor Audio

customer service: 800.262.4671 x772

• Lower system volume control

• Lower input volume control

• Use balanced microphone

CONDITION POSSIBLE SOLUTION

• Turn up WIRELESS volume control

• Make sure mic is plugged into body pack transmitter

• Check gain on belt pack

• Push mic power button

• Turn POWER switch(es) on

• Make sure transmitter power switch is on

• Set receiver and transmitter to same channel

• Replace battery in transmitter

• Try multiple wireless channels

FEEDBACK ISSUES?

Feedback, a howling noise or shrill sound, is self-generated by the sound system.

It's caused by a microphone picking up the sound coming from the speaker and then

re-amplifying it. Once a feedback loop starts, it continues until the system is adjusted.

• Microphone too close, pointing towards or in front of speaker

• Volume setting is too loud for room

• Sound reflecting off hard surfaces

• Point microphone in a different direction

• Keep microphone away from the speaker

• Place speaker in FRONT of the microphone

• Reduce the sound system volume levels