Commodity Axis POLY-REACTOR ViaAqua PR30/30 Instructions Manual - Page 4

Browse online or download pdf Instructions Manual for Aquariums Commodity Axis POLY-REACTOR ViaAqua PR30/30. Commodity Axis POLY-REACTOR ViaAqua PR30/30 6 pages. Multi-media reactor

Print Page

INSTALLATION

1. Choose a desired location for Poly reactor.

2. Place pump in desired location.

3. Secure the pump and connect a piece of tubing from the pump to the center

barbed fitting (IN) secure the tubing with the compression nut. (NOTE: 6ft.

tubing provided is cut to fit for output tubing and intake tube.)

4. Connect discharge tubing to the output of the poly reactor and secure the tubing

with compression nut.

5. Connect the sediment discharge filter to the end of the output tubing.

6. Secure the output tubing and sediment discharge filter with suction cups.

7. Unlatch lid and remove lid

8. Remove the top media sponge and media strainer.

9. Add desired media (follow manufactures guidelines for media requirements

for a given aquarium size. flow rate and precautions.)

10. Replace media sponge and media strainer.

11. Verify the O-ring is clean and free of all media. A small amount of silicone

lubricant can be used to ensure a good seal.

12. Replace lid press directly down so that the down tube against with

the barbed fitting (IN).

13. Secure with latches.

14. Plug pump into a GFCI outlet.

SETUP DIAGRAM

A) HANG ON TANK

Aquarium

Output tube

Intake tube

Maximum

10in media

(not included)

Pump

B) SUMP

Pump

MAINTENANCE

1. Routine maintenance is required to ensure the maximum performance and the

longevity of the ViaAqua

2. For proper operation of the water pump: clean the pump, impeller and intake

strainers every three weeks. Failure to do so will cause premature failure of

the pump.

3. Basic maintenance of the ViaAqua

a) Disconnect the water pump from the power supply prior to removing the pump

from the aquarium.

b) Remove either the prefilter or intake filter strainer. Rinse out prefilter sponge of

all debris.

c) Remove the impeller cover.

d) Once the impeller cover is removed, slide both the impeller and shaft out of

the main body of the pump and clean well. Do not use any soap or detergents

during cleaning.

e) After the impeller and shaft are cleaned, use a small brush to clean inside of the

motor housing .

f) Reassemble above parts and your ViaAqua

the bushing is reassembled properly. Failure to do so will cause permanent

damage to the pump.

Output tube

Intake tube

Sump

water pump.

pump:

pump is ready to use. Make sure

Maximum

10in media

(not included)