Electrolux ESF 6146 S-Visi Instruction Book - Page 5

Browse online or download pdf Instruction Book for Dishwasher Electrolux ESF 6146 S-Visi. Electrolux ESF 6146 S-Visi 18 pages.

Print Page

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot, securing it to the underside of the

work surface. This will prevent waste water from the sink

running into the machine.

2. To a stand pipe provided with vent-hole, minimum internal

diameter 4 cm.

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could prevent

or slow down the discharge of water.

The sink plug must not be in place when the machine is

draining as this could cause the water to syphon back into the

machine.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

Attention!

Our appliances are supplied with a security device to protect

against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated

this can prevent the correct draining of your dishwasher.

We therefore advise you to remove it.

Electrical connection

Information concerning the electrical connection is given on the

rating plate on the edge of the dishwasher's door.

Before plugging the appliance into the wall socket, make sure

that:

1. The mains voltage and current rating at the site of

installation match the nominal voltage and current rating

given on the rating plate.

2. The meter, fuses, mains power supply and wall socket can

all take the maximum load required. Make sure that the

socket and plug are compatible without having to use any

type of adaptor. If necessary, have the domestic wiring

system socket replaced.

To isolate the dishwasher from mains, remove the mains plug.

Important!

The plug must still be accessible after the appliance

has been installed.

In case that the electrical cable has to be replaced,

please contact your local Electrolux Service Centre.

The appliance should not be connected to the

electrical supply by means of an extension cable.

Safety standards require the appliance to be

earthed.

The manufacturer accepts no liability for failure to

observe the above safety precautions.