Common Sense RC SNAP&FLY Owner's Manual - Page 12
Browse online or download pdf Owner's Manual for Toy Common Sense RC SNAP&FLY. Common Sense RC SNAP&FLY 17 pages. 3-in-1 rtf modular airplane system
Step 3. Turn on the transmitter – the transmitter LED (red) will flash for 4 seconds, the
receiver will play music for 3 seconds, and both the transmitter and the receiver LEDs
will become continuously lit. The frequency locking is then established.
To prevent interference if the selected frequency is already occupied then the frequency-
lock will not happen. In this case, disconnect the receiver battery, turn off the transmitter,
select another frequency and repeat steps 1-3.
After establishing the frequency-lock the actuators and the motor in the Base Module
should react to the control lever movements. For safety reasons the throttle control
becomes active only after the throttle lever has been pulled all the way down.
4. Flying the Airplanes
Rotating propellers and moving airplanes can cause bodily injury or property damage. Do
not operate this product in places where injury to people or damage to property might
occur.
A. Getting Ready
1) Connect a fully charged LiPo battery to the receiver in the base module to power up
the receiver (Photo 3D2);
2) Select a frequency with the transmitter frequency dial (Photo 3B);
3) Turn on the transmitter and wait for the frequency-lock music from the base module;
(If frequency-lock doesn't happen, then make sure the LiPo battery connection is
good, and switch off the transmitter, select another frequency and repeat 3.)
4) Choose an airplane module (the canard plane, the biplane or the V-tail plane) and
connect it to the base module to form an airplane;
5) Select the mixing type according to the airplane type;
6) Verify proper responses of all the control channels:
i.
the throttle response – pull the throttle lever all the way back to activate the
control, then apply throttle and make sure the motor responses accordingly;
ii.
the mixing responses for the selected airplane:
Plane
Canard
V-tail
Biplane
(Reverse the lever control for reversed control surface responses.)
SNAP&FLY -- Modularized RC Airplanes
Mixing
CX9/860T
(throttle on left)
0
3
1
4
2
5
Table 4A – Verify the correct mixing type selection
www.itcanfly.com
CX9/860U
Control Surface
(throttle on right)
Response
11