Atherton ATT043 User Manual - Page 3

Browse online or download pdf User Manual for Monitor Atherton ATT043. Atherton ATT043 11 pages. 4.3" tvi/ahd test monitor

Print Page

FCC INFORMATION

This Equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to

correct the interference at his own expense.

WARNING

[A shielded-type power cord is required in order to meet FCC emission limits and also to

prevent interference to the nearby radio and television reception. It is essential that only

the supplied power cord be used. ]

[Use only shielded cables to connect I/O devices to this equipment.]

You are cautioned that changes or modifications not expressly approved by the party

responsible for compliance could void your authority to operate the equipment.

[ ]: depend on EUT condition.

This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received; including interference that may

cause undesired operation.

The product must be installed according to the currently valid installation regulations

for EMC to guarantee the designed use and to prevent EMC problems.

The device supplied with this manual is according to the EC, EMC Directive.

1. Charging this unit only from the charger comes with the package.

2. Do not try to replace the battery which secured inside the cabinet.

3. Do not place this monitor near a radiator or heating vent.

4. Do not use monitor in wet areas, or where it may be exposed to rain or water. Do not

spill liquid of any kind on the unit.

5. Use only a damp cloth. Do not use alcohol, spirits, or ammonia to clean the display.

DO NOT ATTEMPT TO CLEAN THE INTERIOR OF THIS UNIT- THIS ACTION MUST

BE PERFORMED BY THE SERVICE TECHNICIAN AS REQUIRED DURING

NORMAL MAINTENANCE.