Formula RX Operating Manual - Page 9

Browse online or download pdf Operating Manual for Bicycle Accessories Formula RX. Formula RX 20 pages.

Print Page

1.2

Installing the pump

- The pump can be supplied in a right-hand (rh) or left-

hand (lh) version for installation on both sides of the han-

dlebar.

Models R1 – R0 – T1 – R1 RACING – R1S have just one

collar that is interchangeable and used with the word "UP"

facing up.

Model RX – T1S has a collar for the right-hand solution

(rh) and one for the left-hand solution (lh).

As a result, the side on which it will be used must be

specified when placing the order.

The installation steps are similar for both models:

Fit the pump body 4a to the handle bar positioning it as

shown in the figure and orientating it in the desired position.

Fix the pump body 4a by mounting the collar 5a so that

the indication "UP" faces the upper part (as shown in the

figure). First tighten the upper screw 5 to a torque setting

of 2.5/3 Nm±5% and then screw 5b to a torque setting

of 2.5/3 Nm±5% using 3 mm (R1/RO) and 4 mm (RX)

hex. socket wrenches.

If the hose length needs to be adjusted, contact the manufacturer, if not proceed with the posi-

tioning of the hose on the bicycle, carefully following the instructions given below:

- the hose needs to be attached to the fork or frame in a way that does not interfere with the free

flow of fluid through the hose;

- the hose should not make curves smaller than a 20 mm radius and should not interfere with

any moving part of the bicycle.

R1Racing

5b 5a