Formula Sound FF2.2 User Manual - Page 10

Browse online or download pdf User Manual for DJ Equipment Formula Sound FF2.2. Formula Sound FF2.2 15 pages.

Print Page

On the FF2.2 set the faders down, all switches to off and volume controls (pots) to minimum. EQ

pots should be set to MID, high and low pass filter pots should be set to the white dots by the

knobs. Set X Fade curve, FX wet/dry and Cue/Master mix pots to mid position.

The phono noise cancelling feature is enabled or disabled by a switch through the front panel

located between the bass and low mid EQ pots. If you require the noise cancelling to be on use a

cocktail stick through the hole and gently set the switch to on, switch is on when depressed

(lower) and to switch it off gently press it again and it will click off. In the off position the switch cap

is nearer the case (higher) and on the switch cap is lower.

Connect FF2.2 to remote power supply and plug remote power supply into mains supply

ensuring it is correct supply (switch mains supply on at wall socket leaving switch at remote

power supply IEC inlet off).

Connect line and phono inputs, microphone, headphone, FX send/return, master to

amplifier/speakers and booth to amplifier/booth monitors.

Check connections then switch FF2.2 on using switch by IEC connector on remote power

supply. Check green neon comes on.

Activate line input and adjust channel gain pot until LED meter is indicating a level of 0dB.

Deactivate line input and switch input switch to phono, play some vinyl and check average

level is still around 0dB, if necessary adjust channel gain pot to achieve 0dB.

Deactivate phono input and switch back to line, reactivate the line input and if you have

adjusted the gain on phono the level will now be above 0dB, there is a gain trim accessible

through the back (connection face) of the FF2.2 adjacent to the relevant input, using a small

flat bladed screwdriver adjust the level so that the LED meter indicates 0dB. Do this for

channel one and channel two and you will have same level for line and phono without having

to adjust the gain providing you continue to use the same equipment into each input (a

different CD player or turntable may require another adjustment).

Leave the line input active and put the channel fader full up, turn the master control up and

the master meter should start to illuminate, set the master control for 0dB on the meter. Now

adjust your amplifier for your required normal (0dB) sound level,

On the channel your gain pot should be around middle position giving room to increase the

level on the channel and similarly your master pot should be around middle position giving

you room to increase the output level using the master.

Now turn up the booth control and the booth meter should start to illuminate, set the booth

control for 0dB on the meter. Now adjust your amplifier for your required normal (0dB) sound

level.

If you require to pan the booth stereo image turn the FF2.2 onto its side and using a small flat

bladed screwdriver adjust the booth pan control indicated by the legend on the base of the

unit. Gently insert the blade into the slot of the control and rotate clockwise or anticlockwise to

achieve the desired amount and direction of panning.