Formula Sound NN106 User Manual - Page 10

Browse online or download pdf User Manual for Mixer Formula Sound NN106. Formula Sound NN106 18 pages. Multi input mixer

Print Page
Formula Sound NN106 User Manual
MONO and SUB BASS outputs
There is a pair of ¼" 3 pole jacks on the back panel with balanced outputs for mono
and sub-bass..

Record output

A record output is provided on a pair of RCA phono sockets.
Remote mute
The remote mute connection is on a 2 pin rectangular connector, shorting pin 1 and
pin 2 will mute the mixer with the exception of the console microphone and any
channel microphones set to MIC buss with MIC buss selected post booth.
This may be used to interface to a fire alarm, if the alarm has a set of isolated contacts
that close on alarm then these may be used directly, otherwise an isolating interface
relay will be required.
SET UP GUIDE
Use the channel back panel gain trims (MIC, Line, Phono) to set the inputs from your
equipment to be reasonably near equal when each type of input is selected while at
the same time ensuring the maximum level at the output is not approaching clipping.
Channel and console MICs all have phantom power switches (17V), so check if your
mics require phantom power and select for those inputs accordingly.
Channel microphones can be sent to the mic buss or included in the stereo mix, when
sent to the mic buss they are not available for cross fader assignment.
The microphone buss can be routed into the booth or routed to bypass the booth, the
console mic always bypasses the booth.
The channel mic assignment switch and booth bypass switch gives flexibility in how
the microphones are routed.
Choose which USB stereo channel is routed to each channel, it may be you only use 1
stereo USB channel in which case you would select USB1 for all channels.
The compressor has recessed pre-sets in the base of the mixer, if adjustment is
required the following approach is suggested. Play a CD with a piece of music that is
reasonably even level on say channel 3, route channel 3 to FX and select compressor
and set FX loop wet/dry pot to wet. Set channel 3 cue on.