Electrolux 10 GN2/1 Installation Manual - Page 29

Browse online or download pdf Installation Manual for Freezer Electrolux 10 GN2/1. Electrolux 10 GN2/1 34 pages. Electrical combi oven, touch and digital
Also for Electrolux 10 GN2/1: Manual (3 pages)

Print Page

• the drain pipe is able to withstand temperatures of at least

100℃.

• there are no constrictions in hoses or elbows in metal pipes,

along the entire drain path.

• horizontal sections where water can collect and stagnate

(minimum slope 5%) are avoided.

E.6

Electrical connection

E.6.1

Electrical connection

IMPORTANT

The connection to the electrical power supply must

be in compliance with the current national and local

regulations.

Before connecting, make sure the voltage and frequency

match that given on the dataplate.

• Connect the appliance to the power supply in a permanent

way with an H07 RN-F type cable.

• Install the power cable in a metal or rigid plastic pipe without

any sharp parts.

• Install ahead of the appliance an omnipolar switch of

suitable capacity with contact opening distance of at least

3 mm.

Install the switch in the building's electrical system, in the

immediate vicinity of the appliance.

• Appliance max. leakage current is 5 mA.

• Install ahead of the appliance a device (interlocked plug,

lockable switch or similar devices) lockable in the open

position during maintenance.

• Connect the appliance to an efficient earthing system.

For that purpose, the connection terminal block has a

terminal with the symbol

• Include also the appliance into an equipotential system. The

equipotential wire must have a section of at least 10 mm

This connection is made with the setscrew marked

located externally near the power cable entry.

IMPORTANT

Only for 400V 3~ models

This appliance can be connected only to a supply

with maximum system impedance no more than:

6 GN 1/1 and 10 GN 1/1 = 0.18 Ω

6 GN 2/1 and 20 GN 1/1 = 0.043 Ω

10 GN 2/1 = 0.033 Ω

In case necessary, please consult your supply

authority for system impedance information.

CAUTION

If the supply cord is damaged, it must be

replaced by the manufacturer, its service

agent or similarly qualified persons in

order to avoid a hazard.

IMPORTANT

The manufacturer declines any liability if the current

national and local regulations and possible safety

regulations are not respected.

E.6.2

Power cable installation in electric models

To connect the power cable to the appliance, proceed as

follows:

1. Remove the left side panel of the oven;

2. If applicable in your model undo the screw fixing the

external box under the oven;

Loose the ring to let the power cable run through the

cable clamp;

6 - 10 grids models

Cable clamp type for 220-240 V 3~

for connecting the earth wire.

Cable clamp type for 380-415 V 3N~ or 3~, 400-430 V 3N~,

440 V 3~ and 480 V 3~

20 grids models

Unsheathe all wires from the cable;

Run the wires toward the terminal block;