Carnation CR1800 User Manual - Page 6
Browse online or download pdf User Manual for Cash Counter Carnation CR1800. Carnation CR1800 7 pages. Bank-grade bill counter
Print PageCARNATION
Feeder Adjustment
The adjusting screw of the feeder aperture on
the back cover has already been set at the factory.
You may need to adjust the feeder aperture if the
counter jams frequently, or the bills are flying out
during counting. Please consult technical support
before attempting any adjustment.
The adjusting screw is very sensitive, move only one notch at a time!
Parts Replacement
1.The resistance piece needs to be replaced
when worn. Pull out the banknote feeder,
press the banknote sliding board down,
and replace the worn resistance piece.
2. In case the counter doesn't turn on, check the
fuse. The fuse is located under the power ca-
ble socket.
Fuse holder
8
CARNATION
Troubleshooting
The machine will automatically perform a system self-test after it is turned on.
Most error codes are caused by blocked or dusty sensors. Check for banknote
jams and use a brush to clean the sensors, then restart the machine.
Code
Problem
E01/02
Left/right counting sensor
E03
Code disc sensor
E04
Feeder sensor
Receiving sensor
E05
The machine is operated in a strong
magnetic field.
E07
MG sensor
The machine is operated under direct
sunlight.
E10
UV sensitivity
E11
Button
Wheels are running without banknotes. Press "RESET" and re-count.
BF
Counterfeit or suspicious banknote.
EE1
Banknote without UV feature.
Counterfeit or suspicious banknote.
EE2
Banknote without MG feature.
Counterfeit or suspicious banknote.
EE3
Banknote without IR feature.
9
Solution
Clean dust off sensor/ Replace sensor
Clean dust off sensor/fasten sensor/
replace sensor
Clean the obstruction/ Test MG function
Clean dust off sensor/ Replace sensor
Keep it away from the strong magnetic
field.
Replace sensor.
Keep it away from direct sunlight.
Lower UV sensitivity
Open top cover, and fasten the connector
of button/ replace the button.
Remove and press "RESET" to continue
counting. If the machine stops frequently,
adjust the sensitivity level.
Remove and press "RESET" to continue
counting. If the machine stops frequently,
adjust the sensitivity level.
Remove and press "RESET" to continue
counting. If the machine stops frequently,
adjust the sensitivity level.