Bosch 9000240475 Operating & Installation Instruction - Page 11

Browse online or download pdf Operating & Installation Instruction for Dryer Bosch 9000240475. Bosch 9000240475 28 pages.

Print Page

Installation

step by step

1. Unpack the dryer.

2. Remove all objects from the

drum.

3. Check the dryer for visible

damage.

4. Position the dryer near the

installation

location.

5. Have the power supply cord

fitted by an authorized

technician

(see page 8).

6. Move the dryer to its final

location

and align.

Do not slide dryer across the

floor if height-adjustable

feet

have been extended.

Feet and/or

dryer base may be damaged

dryer is slid across floor with

height-adjustable

feet extended.

7. Position and then level the

dryer.

The dryer should be level with

all four feet firmly on the

ground. The dryer must not

wobble.

If the dryer is not level or if it

does wobble, the feet must be

adjusted.

Adjust the

height-adjustable

feet until the

dryer does not rock and is level,

both front-to-back

and

side-to-side.

8. Insert plug into the wall

receptacle.

Built under

Installation

The appliance can be built

under; that is, you can instaii the

dryer under-counter

in a kitchen

cabinet opening. The cabinet

opening should be square and

have dimensions

as shown in the

figure.

600 mm minimum//23

5/8"

600 mm minimum//23

5/8"

850 mm minimum//33

1/2"

If installed under a countertop,

the countertop

must be

continuous

and securely

attached

to neighboring

cabinets.

An opening of at least 31 square

inches (200

cm 2)

must be avail-

able at the front and side of the

closet.

Check

list before

using the dryer

1. Check that steps 1-8 have

been implemented

properly.

2. Ensure that the dryer is

connected

to the power supply.

3. Read the operating

instructions

to understand

how your dryer

operates.

4. Conduct

an appliance

test:

13 Check that the drum is

empty.

13 Close the dryer door.

13 Switch the dryer to "Extra

Dry" and then press the

Start button.

13 After 3-5 minutes

press the

Stop button and open the

door.

If the interior of the dryer feels

warm, the dryer has been

connected

properly.

Switch the dryer to "OFF".

If the dryer does not work,

switch the dryer to "OFF".

Look in the troubleshooting

section (page 21) of the

OPERATING

INSTRUCTIONS

and find the fault.

Preparing

to transport

the dryer-

step

by step

1. Rotate the program

selector

to "OFF".

2. Pull out power supply plug.

3. Place any accessories

in the

drum.

Close the door and secure with

adhesive tape.

Screw the height-adjustable

feet of the dryer into the

housing to prevent them from

being damaged

during

transportation.