Andersen Windows & Doors Andersen 1000 Installation Manual - Page 2
Browse online or download pdf Installation Manual for Door locks Andersen Windows & Doors Andersen 1000. Andersen Windows & Doors Andersen 1000 15 pages. Handle set and closer
Print Page1. INSTALL OUTSIDE AND INSIDE TRIM pLATES:
A.
Insert screw bosses on exterior
trim plate through pre-drilled
holes on exterior of door.
B.
Place interior trim plate against
interior surface of door. Line up
small holes in interior trim plate
with pre-drilled holes on interior
of door.
C.
Insert two (2) #6 x 0.8" screws
through interior trim plate holes
and thread into exterior trim plate
screw bosses. Do not tighten
screws at this time
2. SET LATCH BOLT FOR LEFT OR RIGHT HINGED DOOR:
A.
The rounded portion of the latch
bolt needs to be facing the handle
side Z-bar. If latch bolt is in correct
position, proceed to Step 3. Rotate
the latch bolt to correct position for a
left hinge or right hinge door.
B.
Position the lockcase so that the
case is in the up position as shown.
Remove the face plate from the
lockcase by unscrewing face plate
screw.
C.
Rotate the latch bolt to the correct
position for a left hinge or right hinge
door.
D.
Once latch bolt is in correct position,
reattach face plate to lockcase.
STEP 1a
SCrEw
BOSS
EXTEriOr
TriM PLaTE
DOOr
EXTEriOr ViEw
STEP 2a
rOunDED
POrTiOn
OF LaTCH
BOLT
FaCE
PLaTE
rigHT HingE inSTaLLaTiOn
STEP 2B
FaCE PLaTE
SCrEw
FaCE
PLaTE
2
STEP 1B
inTEriOr
TriM PLaTE
DOOr
inTEriOr ViEw
STEP 2C
LOCkCaSE
FaCE PLaTE
SCrEw
TOP ViEw
FaCE
PLaTE
STEP 2D
TigHTEn FaCE
uP POSiTiOn
PLaTE SCrEw
arrOw
LOCkCaSE
LaTCH BOLT
rigHT HingE
inSTaLLaTiOn
rEaTTaCH
FaCE PLaTE
STEP 1C
inTEriOr
TriM PLaTE
#6X0.8" SCrEw
DOOr
inTEriOr ViEw
rOTaTE LaTCH
BOLT
LOCkCaSE
LOCkCaSE
LEFT HingE
inSTaLLaTiOn