Community Point Source 800 Installation And Operational Manual - Page 8

Browse online or download pdf Installation And Operational Manual for Speakers Community Point Source 800. Community Point Source 800 17 pages. I series

Print Page

Community Point Source 800 Installation And Operational Manual

GRILLE REMOVAL / HORN ROTATION

The horns on full-range loudspeakers

(IP6/8-1122,

IP6/8-1152,

and IP8-0002) can be rotated 90° by

removing the grille, rotating the horn

and then reinstalling the horn and

grille.

Remove the screws holding one

Community grille retention bar to the

cabinet. Remove the bar and loosen

the grille. Then remove the other

retention bar and pull the grille off and

set aside. Keep the rubber extrusions

protecting the top and bottom edges

of the grille in place (Figures 3a, 3b).

Remove the screws and washers

holding the horn in place (Figure 3c).

Carefully pull the horn forward, rotate

it 90° and push back into place, aligning

the screw holes (Figure 3d).

Reattach the horn using the same

washer

and

screw

(Figure 3e).

Flex the grille slightly to fit it back

on the cabinet (one side at a time).

Reattach one grille retention bar, then

flex the grille, align and attach the

other side. Fully tighten the screws

only after both sides have been

secured (Figure 3f).

Note: The grille retention bars will only align with

the threaded inserts in one direction - refer to

the product view for orientation. All fasteners

should be in place and fully tightened to prevent

any undesirable noise from vibration.

Page 8

IP8-1153

5mm x 20mm

Socket Head

Screw

Figure 3a. Remove one retention

bar, loosen that side of the grille and

then remove the other retention bar

combination

Figure 3c. Remove the screws

and washers holding the

horn in place and set aside

Figure 3e. Reattach the horn

Grille

Retention Bar

Grille

5mm x 25mm

(18-8)

Socket Screw

5mm (18-8)

Flat Washer

Quick Start Guide

Figure 3b. Remove the grille and

set aside for reattachment

Figure 3d. Rotate the horn

and realign holes

Figure 3f. Reinstall the grille one side

at a time with correct orientation

of the grille retention bars.

I SERIES IP800/IP600, IS800/IS600