Bosch Programme Table Installation And Operating Instructions Manual - Page 13

Print Page

Bosch Programme Table Installation And Operating Instructions Manual

Washing and drying options

B (Spin speed) button

Rinse Hold

Unbalanced load

detection system

option button

set button

Washing options

T - (Prewash)

- (Intensive)

Q - (Easy-iron)

R - (Water Plus)

R - Flexi Time

C - Signal

0 (Finished in time)

button

The spin speed can be individually adjusted for each programme.

To set the spin speed, press the B (Spin) button repeatedly until the

required spin speed is displayed.

$ (Rinse stop) deactivates the spin function.

The laundry remains in the rinsing water.

The automatic unbalanced load detection system ensures that the laundry

is evenly distributed using several initial spins. If the laundry is extremely

unevenly distributed, the speed of the final spin is reduced or the spin

cycle is not performed for safety reasons.

The set washing programmes can be individually adjusted.

To choose the required washing option:

press the option button repeatedly until the required washing option is

selected (indicator lamp flashes).

Press the set button to switch the washing option on or off (indicator

lamp is lit/not lit).

If you press and hold the option button, the appliance scrolls through all

the washing options.

Prewash at 35 °C. Suitable for heavily soiled laundry.

Prolonged washing time. Suitable for heavily soiled laundry with dried-on

stains. Cannot be combined with R Flexi Time.

Special spin sequence with subsequent fluffing. Gentle final spin at

reduced speed. Slightly increased residual moisture in the laundry.

Reduces creasing and laundry is easier to iron.

Increased water level and additional rinse cycle. For regions with very soft

water or for further improving the rinsing result. Any detergent residues

are better removed.

Sets the washing time: normal-medium-short.

Activates or deactivates the audible signal.

You can postpone the start of the programme before it begins. Using the

remaining time, you can determine when the selected programme is to

end. The remaining time can be set in one-hour increments, up to a

maximum of 24 hours. Press the 0 (Finished in) button repeatedly until

the required number of hours is displayed.

Then press the A (Start/Pause) button. The programme will start after a

delay according to the set remaining time. The time required until the end

of the programme is shown on the display.