Bosch Series 4 Instruction Manual - Page 8

Print Page

Moving the appliance by the gas line or door handle

Do not move the appliance while holding the gas line; the gas

pipe could be damaged. There is a risk of a gas leak! Do not

move the appliance while holding it by the door handle. The

door hinges and door handle could be damaged.

Electrical connection

Caution!

Have the appliance set up by your after-sales service. A 16 A

■

fuse is required for connection. The appliance is designed for

operation at 220-240 V.

If the electricity supply drops below 180 V, the electrical

■

ignition system does not work.

Any damage arising from the appliance being connected

■

incorrectly will invalidate the guarantee.

If the supply cord is damaged, it must be replaced by the

■

manufacturer, its service agent or similarly qualified persons

in order to avoid a hazard.

For the after-sales service

Caution!

The appliance must be connected in accordance with the

■

data on the rating plate.

Only connect the appliance to an electrical connection that

■

meets the applicable provisions. The socket must be easily

accessible so that you can disconnect the appliance from the

electricity supply if necessary.

Please ensure the availability of a multi-pin disconnecting

■

system.

Never use extension cables or multiple plugs.

■

For safety reasons, this appliance must only be connected to

■

an earthed connection. If the safety earth terminal does not

comply with regulations, safety against electrical hazards is

not guaranteed.

You must use a H 05 W-F type cable or equivalent for the

■

appliance connection.

Levelling the cooker

Always place the cooker directly on the floor.

Pull out the plinth drawer and lift it up and out.

There are adjustable feet at the front and rear on the inside of

the plinth.

Use an Allen key to raise or lower the adjustable feet as

necessary until the cooker is level (picture A).

Push the plinth drawer back in (picture B).

Setting up the appliance

The appliance must be set up directly on the kitchen floor

■

and in line with the specified dimensions. The appliance must

not be set up on any other object.

The distance between the top edge of the oven and the

■

bottom edge of the extractor hood must meet the

requirements of the extractor hood manufacturer.

Ensure that the appliance is not moved again after set up.

■

The distance from the high output burner or wok burner to

the fronts of the adjacent units or the wall must be at least 50

mm.

Measures to be noted during transport

Secure all mobile parts in and on the appliance using an

adhesive tape that can be removed without leaving any traces.

Push all accessories (e.g. baking tray) into the corresponding

slots with cardboard at the edges, in order to avoid damaging

the appliance. Place cardboard or similar between the front and

rear side to prevent knocks against the inside of the glass door.

Secure the door and, if available, the top cover to the appliance

sides using adhesive tape.

Keep the original appliance packaging. Only transport the

appliance in the original packaging. Observe the transport

arrows on the packaging.

If the original packaging is no longer available

pack the appliance in protective packaging to guarantee

sufficient protection against any transport damage.

Transport the appliance in an upright position. Do not hold the

appliance by the door handle or the connections on the rear, as

these could be damaged. Do not place any heavy objects on

the appliance.