Anderson Manufacturing SS-2 Assembly & User Manual - Page 3
Browse online or download pdf Assembly & User Manual for Spreader Anderson Manufacturing SS-2. Anderson Manufacturing SS-2 4 pages. 36 inch professional drop spreader
Operation
1) Before filling hopper, make sure spread-
er handle lever is in the "OFF" position.
Always fill spreader on sidewalk or drive,
not on the lawn.
2) Loosen rate control knobs and move the tie
bar to setting recommended for the product
applied. Retighten knobs. If setting is not
known, refer to "Determing Application Rates"
section of this book.
3) Always push spreader, do not pull. Start
spreader in motion and as it passes over
the area to be treated, push handle lever to
the "ON" position. Close handle lever at the
end of each pass.
Determining Application Rates
The following procedure provides a means of accurately deter-
mining drop spreader settings when settings do not appear on
the package, or to "fine tune" the manufacturer's recommended
settings. Spreader rates can vary due to walking speed, condi-
tion of turf, humidity, physical characteristics of the product
being applied, or condition of the spreader. It is good practice to
double check settings using the following method:
PROCEDURE
1) The manufacturer will recommend
coverages on the product package.
Generally, it is stated as applying
a certain number of pounds of
product per 1,000 square feet.
2) Determine the amount of material
in pounds to cover 100 square
feet. Add two zeros to weight
of bag and divide that by the
square foot coverage.
3) To change the decimal portion
of answer in step #2 to ounces,
multiply decimal portion by 16.
4) On a clean sidewalk or driveway, measure out 33.3 feet - the
distance required to cover 100 square feet.
5) Add a measured amount of product to the spreader - 2 to 3
times the recommended rate. Operate spreader at a brisk walk-
ing speed (3 mph of 33.3 feet in 5 seconds) over the measured
distance. Empty the spreader and weigh the amount left.
Compare with the beginning amount; the difference is the
amount applied. Adjust the setting up or down to achieve the
correct application rate.
4) Operate spreader at 3 MPH pace. (33.3
feet in 7.5 seconds)
5) Apply two header strips at each end of
area to treated and then proceed lengthwise
between the header strips. Be sure to over-
lap the wheel tracks slightly to prevent
streaking.
6) When applying lime, do not use lime-
stone that is so finely ground that it will pack
inside the hopper, or use hard, abrasive par-
ticles which will damage the spreader. Use
only compacted, free-flowing, non-abrasive
lime products.
EXAMPLE
The contents of this
package (25 lbs.)
covers 2,000 square
feet.
2,500 divided by 2,000
square feet = 1.25 lbs.
0.25 x 16 oz. = 4 oz.
Total weight = 1 lb.- 4 oz.
Maintenance
1) Never store unused material in spreader.
Return unused product to its original container.
2) Set rate slide on the highest number, open
spreader and spin wheels to remove excess
material.
3) Wash out hopper thoroughly after each use to
remove material clinging to surfaces. Pay close
attention to area between the shutoff bar and
hopper. Allow spreader to completely dry.
4) Oil bottom of hopper, control housing spring and
agitators at the center bearing. Lubricate axle.
"Open"
Oil
3
Oil
Oil
Grease
Grease