Community I SERIES Instructions Manual - Page 5

Browse online or download pdf Instructions Manual for Amplifier Community I SERIES. Community I SERIES 8 pages. For indoor modular vertical arrays
Also for Community I SERIES: Instructions Manual (12 pages)

Print Page

IV6-LAU APPLICATIONS

1. Under-balcony mount for a two to three

element IV6 array. The LAU provides a

very low profile mechanism for rigidly

mounting a small array to a solid overhead

surface. The built-in 0°, 5°, 10°, and 15°

aiming options allow adjustments to the

overall array aiming angle.

I SERIES BalancePoint™ Flyware instructions are available by following this link

to the Community website:

finding BalancePoint™ Flyware.

WARNING: For safety reasons, the center of mass of the array MUST be

located directly beneath the IV6-LAF-PBB Array Frame. If the center of mass

is located behind the array frame, it may result in an unsafe rigging condition.

To verify center of mass is directly beneath the Array Frame, build the intended array

(using the IV6-LAF-PBB Array Frame) in EASE® Focus 3 (EF3) and verify the center of

mass position meets this condition as displayed the "Rigging" pane. (See image at

right from EF3). IMPORTANT: The LAU can only be used with LAF pin positions 3-12.

Always have rigging safety conditions verified by a certified engineer before

installation. Failure to do so can lead to severe injury or even death!

I SERIES

3. Suspend I SERIES 600 or I SERIES

800 subwoofers behind an array of up

to six (6) IV6-1122 elements using the

BalancePoint™ Flyware SBR54 (54" long

Sub Behind Fly Rails). For this application,

the IV6-LAU must be bolted to the IV6-LAF

in the 0° position.

4. Suspend an array of up to six IV6-

1122 elements using the BalancePoint™

Flyware IAF55 (55" wide Isometric Array

Frame). The IAF55 allows flying a central

IV6-1122 array with additional I SERIES fill

speakers to the left and right. The IAF55

may also be combined with the SBR54.

For this application, the IV6-LAU must be

bolted to the IV6-LAF in the 0° position.

www.communitypro.com/products/i-series

IV6-LAU Instructions

2. Suspend an array of up to six IV6-1122

or up to three IV6-118S elements (not to

exceed WLL of 500 lbs. @ 10:1 safety ratio)

from one or more load-rated eyebolt(s)

or other similar sized load-rated lifting

hardware.

IV6-LAU must be bolted to the IV6-LAF in

the 0° position.

and

For

this

application,

the

Page 5