ANDERSON-NEGELE MPI-200 Product Information - Page 2

Browse online or download pdf Product Information for Adapter ANDERSON-NEGELE MPI-200. ANDERSON-NEGELE MPI-200 8 pages. Programming adapter

Print Page

C O N T R O L S

Connecting the sensor

1. Connect the sensor to the PC via the USB port.

2. The graphic user interface now refreshes and shows the sensor (e.g. level switch

NSL-M).

Advice

If the sensor is not displayed, check the power supply selection and change it

if necessary.

Signal ﬂ ow while parametrization

Negele-S

e. g. Level Sen

M12 connector assignment (connector 1)

1: +Auxiliary voltage

2: -Auxiliary voltage 4...20 mA

3: Data line for PC interface must

not be wired

4: Data line for PC interface must

not be wired

Supply voltage/power supply

The equipment is delivered with the programming adapter set to a power supply

from the PC. However, it is also possible to wire the programming adapter into

the system and program the sensor afterward. To do this, the parameter for the

power supply must be changed to "External supply". Proceed as follows:

1. Select the "Power supply MPI-200" parameter

Select the "Power supply MPI-200" parameter

2. Press the button

and change the power supply parameter from

"PC M12 not connected"

"External, M12 connected"

using the arrow button

3. Press the button

to save the change. The mask is refreshed

Advice

If the sensor is supplied from the control center/PLC, ensure that the power supply is set to "external, M12 connected".

A supply from the PC would otherwise be superimposed on the 4...20 mA output signal and lead to an incorrect measur-

ing signal.

ensor

sor NSL-M

Negele

MPI-200

interface

(3)

mA (1)

PLC

Connection of programming adaptor MPI-200

1: External power supply

via M12-plug (optional)

2: USB port for connection

to PC incl. power supply

if not supplied external

3: Connection cable to

NSL-sensor

Electrical connection | Power supply

MPI-200 user interface

USB

(2)

MPI-200 power supply