Bosch WTW87569GR Installation And Operating Instructions Manual - Page 32
Browse online or download pdf Installation And Operating Instructions Manual for Dryer Bosch WTW87569GR. Bosch WTW87569GR 40 pages.
Also for Bosch WTW87569GR: Installation And Operating Instructions Manual (44 pages)
Print Page
Faults and what to do about them
en
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ð on the display panel
and drying has been
interrupted.
é on the display panel. Clean the fluff filter and press the Start button ~ Page 26.
selfCleaning on the '
display panel.
Dryer does not start.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
Laundry is not dried cor-
rectly or is still too damp.
* Depending on the model
32
Cause/remedy
Empty the condensate container; ~ Page 27 and the dryer; ~ Page 15.
■
If the optional condensation drain* is installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and rinse the hose. Lay
the hose without any kinks.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out
the condensate container while this is displayed.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 23.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 21.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
After the end of the programme, warm laundry feels damper than it actually
■
is. Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 23.
Select a programme with a longer drying time or increase the drying level.
■
This does not increase the temperature.
Select a timed programme for subsequent drying of laundry that is still
■
damp ~ Page 21.
If you have exceeded the maximum load for the programme, the laundry
■
may not be dried properly.
Clean the moisture sensor in the drum. The sensor may become covered by
■
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 30.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips ~ Page 20.