Bosch WTW87F90CH Installation And Operating Instructions Manual - Page 40
Browse online or download pdf Installation And Operating Instructions Manual for Dryer Bosch WTW87F90CH. Bosch WTW87F90CH 48 pages.
Also for Bosch WTW87F90CH: Installation And Operating Instructions Manual (32 pages)
Print Page
Help with the appliance
en
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
The appliance will not start.
Creasing.
Water is leaking out.
Programme duration displayed
changes as drying progresses.
Laundry is not dried properly or
is still too damp.
The programme will not start
Drying taking too long.
40
Cause/remedy
Check the mains plug and the fuses.
Load exceeded or incorrect programme selected for a type of fabric.
■
All the required information can be found in the programme
table.~ Page 23
Remove laundry from the drum as soon as the drying programme
■
has finished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the
appliance.~ Page 14
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
After the programme has ended, warm laundry feels damper than it
■
actually is. Spread out the laundry and let it cool down.
Adjust the drying time or increase the degree of dryness. This will
■
extend the drying time but the temperature will remain the same.
Select a timed programme to add extra drying time for laundry that is
■
still damp.
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.~ Page 23
■
Clean the moisture sensor in the drum. The sensor may become cov-
■
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.~ Page 37
Drying has been interrupted as a result of a power cut, because the
■
condensation container is full or because the maximum drying time
has been exceeded.
Note:
See also the laundry tips.~ Page 27
Make sure that:
The door is closed.
■
E push 3 sec. (Childproof lock) has been deactivated
■
You have pressed Start A
■
Note:
If the programme has been delayed by setting 3 (ready in), the
programme will start later.
The appliance may have fluff in it. This will increase the drying time.
■
Remove the fluff.~ Page 32
If the air inlet on the appliance is blocked or not fully open, the drying
■
time may increase. Make sure that the air inlet remains unob-
structed.
If the ambient temperature is lower than 15 °C or higher than 30 °C,
■
this may increase the drying time.
Inadequate air circulation in the room may increase the drying time.
■
Make sure the room is adequately ventilated.