Bosch WTW87NH1UC Use And Care Manual / Installation Instructions - Page 20

Browse online or download pdf Use And Care Manual / Installation Instructions for Dryer Bosch WTW87NH1UC. Bosch WTW87NH1UC 22 pages.

Bosch WTW87NH1UC Use And Care Manual / Installation Instructions
Preparing to transport the dryer - step by
step
Press the center of the Program Selector to switch off
1.
the appliance.
Pull out power supply plug.
2.
Place any accessories in the drum.
3.
Close the door and secure with adhesive tape.
4.
Screw the height-adjustable feet of the dryer into the
5.
housing to prevent them from being damaged during
transportation.
Removing residual water from dryer
Pull out the condensation tank and empty it.
1.
Push the tank back in place until you feel it lock into
2.
position.
Switch on the appliance, select any drying program
3.
and press Start/Pause.
Wait for 5 minutes while condensation water is drained
4.
or pumped to tank.
Empty the condensation container, steps 1 and 2
5.
above, again.
If installed, remove the drain hose from the stand pipe,
6.
washbasin or floor drain.--> Page 16-17
CAUTION
9
Secure the drain hose to the back of the dryer to
prevent it from hanging loose or being damaged.
Do not kink the drain hose.
Switch off the appliance.
7.
Disconnect the appliance's power cord from the
8.
receptacle.
The appliance is now ready to be transported.
CAUTION
9
Risk of material damage/damage to the
appliance.Despite draining, there will always be
some residual water in the appliance.Any residual
water may leak out and cause material damage;
therefore, the appliance should always be
transported upright.
20

Reversing the door - step by step

Tip: To reverse your dryer door side:
Use only T20 (Torx) type screw driver to remove and
reinstall door screws.
Do not use any other tools to reverse the door (hinge
or latch).
Press the center of the Program Selector to switch off
1.
the appliance. Remove the power plug from wall
outlet. Open the door completely.
Remove the hinge screws from the dryer side then
2.
remove the door and hinge assembly from the dryer
housing.
Place the door on a flat, smooth, secure surface such
3.
as a towel or cloth lying on the floor or table.
Remove screws from the hinge insert and then remove
4.
it from the door.