Andis SLII Use & Care Instructions Manual - Page 3
Browse online or download pdf Use & Care Instructions Manual for Hair Clipper Andis SLII. Andis SLII 14 pages. Andis company hair trimmer - use and care guide
Also for Andis SLII: Use And Care Manual (2 pages), Use And Care (2 pages)
Print Page
Grounded
Grounded
Outlet
Grounded
Outlet
Outlet
Metallic
Metallic
Screw
Metallic
Screw
Screw
Grounded
Grounded
Pin
Grounded
Grounded
Pin
Pin
Grounded
Outlet Box
Grounded
Outlet Box
Outlet Box
FiGURE A
FiGURE D
Blade
Upper
Blade
Lower
Hole in
Blade
Upper
Blade
Blade Screws
FiGURE G
Armature
Pin
Blade
Yoke
FiGURE i
4
Adapter
Adapter
Adapter
Adapter
Adapter
Adapter
Grounded
Grounded
Outlet Box
Grounding Screw
Grounded
Outlet Box
Outlet Box
FiGURE B
FiGURE C
OIL
BLADE SCREWS
FiGURE E
FiGURE F
HAIR GUARD
Nylon
Roller
(Ball)
FiGURE H
POWER
SCREW
FiGURE J
DANGER:
risk of electric shock. If repair or replacement of the cord or plug is
necessary, do not connect the grounding wire to either flat-blade
terminal. The wire with insulation having an outer surface that is green
with or without yellow stripes is the grounding wire. Check with a
qualified electrician or serviceman if the grounding instructions are not
Tab for
completely understood, or if in doubt as to whether the appliance is
Tab for
Tab for
properly grounded. Do not modify the plug provided; if it will not fit the
Grounding Screw
Grounding Screw
outlet, have the proper outlet installed by a qualified electrician. This
appliance is for use on a nominal 120-volt circuit, and has a grounding
plug (Figure A). A temporary adapter, (Figures B & C) may be used to
connect this plug to a 2-pole receptacle (Figure B) if a properly grounded
outlet is not available. The temporary adapter should be used only until a
properly grounded outlet (Figure A) can be installed by a qualified
electrician. The green colored rigid ear, lug, or the like extending from the
adapter must be connected to a permanent ground such as a properly
grounded outlet-box cover. Whenever the adapter is used, it must be
held in place by a metal screw.
opEratING INStructIoNS
Please read the following instructions before using your new Andis
trimmer. Give it the care that a fine precision built instrument deserves
and it will give you years of service. Before starting trimmer remove blade
guard (some models may not have a blade guard). Plug cord into
electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as
noted on the unit. To start trimmer move switch button to ON position, to
stop, move switch button back to original position. After using your Andis
trimmer, rewrap cord and store in a safe place.
uSEr maINtENaNcE
The internal mechanism of your trimmer has been permanently lubricated
at the factory. Other than the recommended maintenance described in
this manual, no other maintenance should be performed, except by
Andis Company or an Andis Authorized Service Station. To find an
Andis Authorized Service Station near you log on to www.andis.com or
contact our customer service department: 1-800-558-9441 (U.S.) or
1-800-335-4093 (Canada).
Improper use of the grounding plug can result in a
5