Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K Operating/Safety Instructions Manual - Page 10

Browse online or download pdf Operating/Safety Instructions Manual for Drill Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K. Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K 45 pages. Cordless hammer drill

Print Page

BM 1619929800 12-07

12/4/07

8:32 AM

Page 10

INSTALLING & REMOVING ACCESSORIES

FIG. 6

3-JAW CHUCK

For small bits, open jaws enough to insert the

bit up to the flutes. For large bits, insert the bit

as far as it will go. Center the bit as you close

the jaws by hand. This positions the bit

properly, giving maximum contact between the

chuck jaws and the bit shank (Fig. 6).

To tighten chuck, insert key into each of the

three key holes in succession and tighten

clockwise firmly.

The chuck can be released by using one hole only.

Note: The 3-Jaw Chuck is for use only in "Drill

only" mode. The 3-Jaw Chuck is not for use

when drilling with hammering action.

AUXILIARY HANDLE

FIG. 7

The auxiliary handle will provide additional

control, support and guidance for the tool. The

WING KNOB

handle is adjustable around the 360° handle

collar mount.

To mount, loosen wing knob and slide handle

completely over chuck onto the collar mount

and tighten wing knob (Fig. 7).

AUXILIARY

HANDLE

DEPTH GAUGE

FIG. 8

Your drilling depth can be pre-set and/or

DEPTH GAUGE

repeated by using the depth gauge.

RELEASE LEVER

Setting depth: After the auxiliary handle is

installed, make sure the accessory has been

DEPTH GAUGE

fully inserted into the tool holder before setting

the depth gauge (Fig. 8).

To adjust depth, push down on the depth

gauge release lever, slide the depth gauge to

desired depth and release pressure on lever to

lock the depth gauge in place (Fig. 8).

-10-