Andis 60130 Use & Care Instructions Manual - Page 5

Browse online or download pdf Use & Care Instructions Manual for Electric Shaver Andis 60130. Andis 60130 16 pages.

Print Page

USING THE ATTACHMENT COMBS

You can set the blades for a longer cut by using any of the attachment combs made

for your Andis clipper. The combs mount easily; simply slip the cutter blade teeth into

comb and snap the comb down (Figures D & E). To remove, simply snap off. These

attachment combs guide hair into the blades and give you precise control of hair

lengths. The length of trim is indicated on the attachment comb. Use the chart to find

the approximate lengths of cut. Different blade angles in relation to the skin, thickness

and texture of the hair will vary the cutting length.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated at the

factory. Other than the recommended maintenance described in this manual, no other

maintenance should be performed, except by Andis Company or an Andis authorized

service station.

BLADE TEMPERATURE

Due to the high speed nature of Andis clippers, please check for blade heat often,

especially on close cutting blades. If blades are too hot, dip the blades only into Andis

Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. If you have

a detachable blade unit, you can change your blade in order to maintain a comfortable

temperature; using multiple blades of the same size is popular among groomers.

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES

Blades should be oiled before, during, and after each use. If your clipper blades leave

streaks or slow down, it's a sure sign blades need oil. Hold the clipper with the blades

pointing down to prevent oil from getting into the motor. Place a few drops of Andis

Clipper Oil on the front and side of the cutter blades (Figure F). Wipe excess oil off

blades with a soft dry cloth. Spray lubricants contain insufficient oil for good lubrication,

but are an excellent clipper blade coolant. Always replace broken or nicked blades to

prevent injury. You can clean the excess hair from your blades by using a small brush or

worn out toothbrush. To clean the blades we suggest to immerse the blades only into

a shallow pan of Andis Blade Care Plus, while the clipper is running. Any excess hair and

dirt that has accumulated between the blades should come out. After cleaning, turn

your clipper off and dry blades with a dry cloth and start clipping again.

BLADE & CLIPPER/TRIMMER REPAIR SERVICE

When the blades of your Andis clipper become dull after repeated use, it is advised to

purchase a new set of blades available through your Andis supplier or through an

Andis authorized service station. Some blade sets can be resharpened–contact Andis

Company for information on resharpening. If you have a problem contacting your

Andis supplier, contact the Andis Company customer service department at

1-800-558-9441 or email at [email protected].

CAUTION: Never handle your Andis clipper while you are operating a water faucet,

and never hold your clipper under a water faucet or in water. There is danger of

electrical shock and damage to your clipper. Andis Company will not be

responsible in case of injury due to this carelessness.