Comnet FTA2C1M1 Installation And Operation Manual - Page 6

Browse online or download pdf Installation And Operation Manual for Multiplexer Comnet FTA2C1M1. Comnet FTA2C1M1 6 pages. 2 audio channels + 1 contact closure fra2c1 series fta2c1 series

MECHANICAL INSTALLATION INSTRUCTIONS

INsTALLATION CONsIDERATIONs

This fiber-optic link is supplied as a Standalone/Rack module. units should
be installed in dry locations protected from extremes of temperature and
humidity.
C1-Us, C1-EU, C1-AU OR C1-CH CARD CAGE RACKs
CAUTION: Although the units are hot-swappable and may be installed
without turning power off to the rack, ComNet recommends that the
power supply be turned off and that the rack power supply is disconnected
from any power source. Note: Remove electrical connector before
installing in card cage rack.
1. Make sure that the card is oriented right side up, and slide it into the card
guides in the rack until the edge connector at the back of the card seats in
the corresponding slot in the rack's connector panel. Seating may require
thumb pressure on the top and bottom of the card's front panel.
CAUTION: Take care not to press on any of the LEDs.
2. Tighten the two thumb screws on the card until the front panel of the
card is seated against the front of the rack.
WARNING: unit is to be used with a listed Class 2 power supply.

IMPORTANT sAFEGUARDs:

A) Elevated Operating Ambient - If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment
may be greater than room ambient. Therefore, consideration should
be given to installing the equipment in an environment compatible
with the maximum ambient temperature (Tma) specified by the
manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should
be such that the amount of air flow required for safe operation of the
equipment is not compromised.
© 2013 Communications Networks Corporation. All Rights Reserved. "ComNet" and the "ComNet logo" are registered trademarks of Communication Networks, llC.
FIGURE A
Dimensions are for a standard ComNet™ one slot module.
3 Corporate Drive | Danbury, Ct 06810 | uSa
t: 203.796.5300 | F: 203.796.5303 | teCh Support: 1.888.678.9427 | [email protected]
8 turnberry park roaD | GilDerSome | morley | leeDS, uk lS27 7le
t: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | [email protected]
FTA/FRA2C1(M,S)1 AND FXA2C1(M,S)1
INS_F(T,R)A2C1(M,S)1_FXA2C1(M,S)1_REV– 04/25/12 PAGE 6
.156 [3.96 mm]
.313 [7.95 mm]