Electrolux EGG 9363 User Manual - Page 11

Browse online or download pdf User Manual for Hob Electrolux EGG 9363. Electrolux EGG 9363 16 pages. Hob
Also for Electrolux EGG 9363: User Manual (16 pages), User Manual (20 pages)

Print Page

of gas you use (see table in "Techni-

cal Information" chapter).

Assemble the parts, follow the same

procedure backwards.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

7.4 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

Light the burner.

Turn the knob on the minimum posi-

tion.

Remove the knob.

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2

of a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

7.5 Electrical connection

• Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• Do not connect the appliance with an

extension cable, an adapter or a multi-

ple socket. There is a risk of fire. Make

sure that the ground connection com-

plies with the standards and regulations

force.

• Do not let the connection cable parts to

heat to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor

who is on the roll of the National Inspec-

tion Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer declines any lia-

bility if these safety measures are

not observed.

The appliance must be connected to a

230 V 50 Hz AC electrical supply.

Before activating the appliance, make

sure the electrical supply voltage is the

same as that indicated on the rating plate.

The rating plate is located on the bottom

of the appliance.

The appliance is supplied with a 3 core

flexible supply cord with a 3 amp plug. If it

is necessary to change the fuse, use a 3

amp ASTA-approved (BS 1362) fuse.

ENGLISH