Electrolux EGG6242 User Manual - Page 13

Browse online or download pdf User Manual for Hob Electrolux EGG6242. Electrolux EGG6242 20 pages. 60cm wide gas hob with 4 burners and individual pan supports.
Also for Electrolux EGG6242: User Manual (20 pages), User Manual (16 pages)

Print Page

CAUTION!

It is important to install the

elbow correctly, with the

shoulder on the end of the

thread, fitted to the hob

connecting pipe.

CAUTION!

Failure to ensure the correct

assembly will cause leakage

of gas.

CAUTION!

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

8.4 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the

type of gas you use (see table in

"Technical Information" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

8.5 Adjustment of minimum

level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

8.6 Electrical connection

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of

fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the equipment beneath the

cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a

contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

ENGLISH