Electrolux EGG64272W User Manual - Page 8
Browse online or download pdf User Manual for Hob Electrolux EGG64272W. Electrolux EGG64272W 20 pages.
Print Page
Choose fixed connections or use a flexible
pipe in stainless steel in compliance with the
regulation in force. If you use flexible metallic
pipes, be careful they do not come in touch
with mobile parts or they are not squeezed.
Also be careful when the hob is put together
with an oven.
Make sure that the gas supply pressure
of the appliance obeys the recommended
values. The adjustable connection is
fixed to the comprehensive ramp by
means of a threaded nut G 1/2". Screw
the parts without force, adjust the
connection in the necessary direction and
tighten everything.
A
A. End of shaft with nut
B. Washer supplied with the appliance
C. Elbow supplied with the appliance
Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).
"Flexible" connection with mechanical
end:
• Natural gas: connection carry out with a
flexible pipe with mechanical end which is
screwed directly on the elbow finishing the
slope of the appliance.
• Butane/Propane: use a flexible tube,
equipped with it's collars if it is worth
visiting over all it's length and if the
appliance runs only on butane. If the
appliance runs on Propane, use a flexible
pipe with suitable metal end.
Flexible nonmetal pipes connection:
If it is possible to easily control the connection
in its full area, you can use a flexible pipe.
Tightly attach the flexible pipe by clamps.
8
ENGLISH
B C
Liquid gas
Use the rubber pipe holder for liquid gas.
Always engage the gasket. Then continue
with the gas connection.
The flexible pipe is prepared for apply when:
• it can not get hot more than room
temperature, higher than 30°C;
• it is no longer than 1500 mm;
• it shows no throttles;
• it is not subject to traction or torsion;
• it does not get in touch with cutting edges
or corners;
• it can be easily examined in order to make
sure its condition.
The control of preservation of the flexible pipe
consists in checking that:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
• the material is not hardened, but shows its
correct elasticity;
• the fastening clamps are not rusted;
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
WARNING!
When installation is complete, make sure
that the seal of each pipe fitting is
correct. Use a soapy solution, not a
flame!
3.3 Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the ones
which are necessary for the type of gas
you use (see table in "Technical Data"
chapter).
4. Assemble the parts, follow the same
procedure backwards.
5. Attach the label with the new type of gas
supply near the gas supply pipe. You can
find this label in the package supplied
with the appliance.
If the supply gas pressure is changeable or
different from the necessary pressure, you
must fit an applicable pressure adjuster on
the gas supply pipe.