Andon KD-926 Operation Manual - Page 13

Browse online or download pdf Operation Manual for Blood Pressure Monitor Andon KD-926. Andon KD-926 19 pages.

Print Page

DN:KD-926-SMSY01 V1.0

Note: It is not intended to provide a basis of any type of rush toward emergency

conditions/diagnosis based on the color scheme and that the color scheme is meant only to

discriminate between the different levels of blood pressure.

12. TECHNICAL ALARM DESCRIPTION

The monitor will show 'HI' or 'Lo' as technical alarm on LCD with no delay if the determined

blood pressure (systolic or diastolic) is outside the rated range specified in part

SPECIFICACIONS. In this case, you should consult a physician or check if your operation

violated the instructions.

The technical alarm condition (outside the rated range) is preset in the factory and cannot be

adjusted or inactivated. This alarm condition is assigned as low priority according to IEC

60601-1-8.

The technical alarm is non-latching and need no reset. The signal displayed on LCD will

disappear automatically after about 8 seconds.

PROBLEM

LCD Display shows

abnormal result

POSSIBLE CAUSE

The cuff position was not correct or

it was not properly tightened

Body posture was not correct during

testing

Speaking, arm or body movement,

angry, excited or nervous during

testing

Irregular heartbeat (arrhythmia)

12/16

Operation Guide

SOLUTION

Apply the cuff correctly and try

again.

Review the "BODY POSTURE

DURING

MEASUREMENT"

sections of the instructions and

re-test.

Re-test when calm and without

speaking or moving during the

test.

It is inappropriate for people with

serious arrhythmia to use this

Electronic Sphygmomanometer.