Dremel DigiLab 3D40 FLEX Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for 3D Printers Dremel DigiLab 3D40 FLEX. Dremel DigiLab 3D40 FLEX 4 pages.

Print Page

OFFLINE SETUP (No Internet Access)

STEP 1:

Ensure the power switch is in the off position.

STEP 2:

STEP 3:

Spool

Holder

FIG. 1

Open

Close Filament Filament

Guide Tube

Install the build

plate holder

using the build

platform clips.

Twist spool door

counter-clockwise

to remove. Place

spool onto holder

with ﬁlament being

fed from the

bottom towards

the back. Thread

ﬁlament through

guide tube.

STEP 4:

Guide Tube Filament Extruder Intake

STEP 5:

Turn on the power switch and the printer will

guide you through the setup process.

WARNING

READ ALL OPERATING/SAFETY INSTRUCTIONS IN THE MANUAL AND

FAMILIARIZE YOURSELF WITH THE DREMEL 3D40 BEFORE SETUP AND USE.

FAILURE TO COMPLY WITH THE WARNINGS AND INSTRUCTIONS MAY RESULT

IN FIRE, EQUIPMENT DAMAGE, PROPERTY DAMAGE, OR PERSONAL INJURY.

2610053097

09/18

Insert ﬁlament

from the guide

tube into the

extruder intake.