Andonstar AD407 User Manual - Page 5
Browse online or download pdf User Manual for Microscope Andonstar AD407. Andonstar AD407 11 pages.
Also for Andonstar AD407: User Manual (14 pages)
Print Page
Assembly
1. Screw the optical bracket on to the base (see the left picture above,P2 ).
2. Once you have done so, if the bracket is not aligned over the base, unscrew the locking ring, adjust the
bracket's
direction,
(After
doing
turn the bracket if sufficient force is applied, but it will not spin freely.)
3. Loosen the small thumbscrews on the optical bracket.
4. Slide the optical stack in to the ring of the optical bracket.
5. Tighten the thumbscrews to hold the optical stack in place.
If done correctly, you should be able to not just turn the focus controller of the optical stack freely, but also
freely adjust the monitor, the angel between the base and the optical bracket, while the rest of
microscope remains in place. If you have any question or problem for assembly, please contact us as soon
as possible, so you won't damage the device during assembly.
Buttons
Power on/off
1
Mode/menu
2
Up
3
Down
4
OK/Start video record
5
Picture capture
6
Infrared sensor (when you are using the
7
and
then
turn
so,
it
will
the
locking
still
be
possible
(P4, buttons)
remote, please point the remote to this so the
device would response)
Focus controller
8
⑩Memory card slot
⑪USB port
⑫HMDI port
6
ring
clockwise
until
to
hold
it
is
tight.
the
base
and