andover SPINDECK Product Manual - Page 5

Browse online or download pdf Product Manual for Turntable andover SPINDECK. andover SPINDECK 12 pages. Belt-drive turntable
Also for andover SPINDECK: Product Manual (16 pages)

Print Page

To Set-up your Spindeck MAX

1. Remove the two transportation locks

(Fig. 1) by applying lateral pressure.

The locks are located on the floating

subchassis at the front left and at the

rear right.

IMPORTANT: Please retain these

locks and reinstall them whenever

your Spindeck MAX requires

shipment.

2. Place the platter over the center

spindle and press down until the two

wire springs snap into the groove of

the spindle. Place the felt mat on the

platter.

IMPORTANT: If your Spindeck MAX

ever requires shipment, please

remove the platter and place it under

the turntable in the carton. If this is

not done the platter may become

dislodged in shipment and cause

damage to the tonearm, dustcover or

cartridge.

3. Insert the two cover hinges into the

slots at the rear edge of the plinth.

Slide the notches in the cover into the

slots at the top edge of the hinges.

Press the spring wires until they click into the spindle groove.

Page 5