Dremel 2200 Versaflame Operating/Safety Instructions Manual - Page 3
Browse online or download pdf Operating/Safety Instructions Manual for Flashlight Dremel 2200 Versaflame. Dremel 2200 Versaflame 10 pages.
Print Page
Find Quality Products Online at:
Before using, check all
W RNING
parts for proper function
and damage to component parts.
Do not use this torch to heat, mold, or
bend plastic sheets, molding or tubing.
Hidden areas such as behind walls, ceilings,
floors, soffit boards and other panels may
contain flammable materials that could be
ignited by the heat gun when working in
these locations. The ignition of these
materials may not be readily apparent and
could result in property damage and injury to
persons.
When working in these locations, keep the
torch moving in a back-and-forth motion.
Lingering or pausing in one spot could ignite
the panel or the material behind it.
Extreme care should be taken when stripping
paint. The peelings, residue and vapors of
paint may contain lead, which is poisonous.
Any pre-1977 paint may contain lead and
paint applied to homes prior to 1950 is likely
to contain lead. Once deposited on surfaces,
hand to mouth contact can result in the
ingestion of lead. Exposure to even low
levels of lead can cause irreversible brain
and nervous system damage; young and
unborn children are particularly vulnerable.
Before beginning any paint removal process
you should determine whether the paint you
are removing contains lead. This can be
done by your local health department or by a
professional who uses a paint analyzer to
check the lead content of the paint to be
removed. LEAD-BASED PAINT SHOULD
ONLY
BE
REMOVED
PROFESSIONAL AND SHOULD NOT BE
REMOVED USING A TORCH.
Persons removing paint should follow
these guidelines:
1) Move the work piece outdoors. If this is not
possible, keep the work area well
ventilated. Open the windows and put an
exhaust fan in one of them. Be sure the
fan is moving the air from inside to outside.
2) Remove or cover any carpets, rugs,
furniture, clothing, cooking utensils and air
ducts.
3) Place drop cloths in the work area to catch
any paint chips or peelings. Wear
protective clothing such as extra work
shirts, overalls and hats.
GlobalTestSupply
www.
4) Work in one room at a time. Furnishings
should be removed or placed in the center
of the room and covered. Work areas
should be sealed off from the rest of the
dwelling by sealing doorways with drop
cloths.
5) Children, pregnant or potentially pregnant
women and nursing mothers should not be
present in the work area until the work is
done and all clean up is complete.
6) Wear a dust respirator mask or a dual filter
(dust and fume) respirator mask which has
been approved by the Occupational Safety
and Health Administration (OSHA), the
National Institute of Safety and Health
(NIOSH), or the United States Bureau of
Mines. These masks and replaceable
filters are readily available at major
hardware stores. Be sure the mask fits.
Beards and facial hair may keep masks
from sealing properly. Change filters often.
DISPOSABLE PAPER MASKS ARE NOT
ADEQUATE.
7) Use caution when operating the torch.
Keep the torch moving, as excessive heat
will generate fumes, which can be inhaled
by the operator.
8) Keep food and drink out of the work area.
Wash hands, arms and face and rinse
mouth before eating or drinking. Do not
smoke or chew gum or tobacco in the work
area.
9) Clean up all removed paint and dust by
wet mopping the floors. Use a wet cloth to
clean all walls, sills and any other surface
BY
A
where paint or dust is clinging. DO NOT
SWEEP, DRY DUST OR VACUUM. Use a
high phosphate detergent or trisodium
phosphate (TSP) to wash and mop areas.
10) At the end of each work session put the
paint chips and debris in a double plastic
bag, close it with tape or twist ties and
dispose of properly.
11) Remove protective clothing and work
shoes in the work area to avoid carrying
dust into the rest of the dwelling. Wash
work clothes separately. Wipe shoes off
with a wet rag that is then washed with
the work clothes. Wash hair and body
thoroughly with soap and water.
Never attempt to use torch as a cigarette,
cigar, or pipe lighter.
-3-
.com