Compac WD1500 Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Outdoor Cart Compac WD1500. Compac WD1500 9 pages. Wheel dolly

Print Page

Safety instructions - LIFTING

1. Make sure that lifting only occurs on a flat and strong surface/floor. If not, lifting with this unit is

prohibited due to risk of danger / damages!

2. The wheel/load should be lifted from the floor.

3. Place the rollers (F) on either side of the wheel that should be lifted. Move the unit as close to

the wheel/load as possible.

4. Loosen the vertical support arm (H) and horizontal support arm (A). By using grip (K) it is

possible to steer the arm with the small support wheel (W) to the opposite side of the

wheel/load. Once the small support wheel (W) is on the opposite side it can be steered behind

the wheel/load. This will prevent the wheel/load from dropping to the opposite side during

manoeuvring.

5. Once you have placed the guide arm (A) correctly, lock its position with the lock (M).

6. !! Lock (L) should be open while lifting or lowering so that the wheel (W) supports the

wheel/load on the opposite side. Kindly note that you should NOT lock position (L). Once you

begin lifting the wheel/load, lock (L) must be open, as this will allow the guide arm to follow the

upwards and downwards movement of the wheel as it is raised and lowered.

7. The lifting can now start. *

* Before you end the lifting procedure, active safety pin (S) so that the manual safety stop is

activated, should a hydraulic leak occur. After a short lifting or lowering action the safety pin (S) will

be activated. The safety pin is spring loaded and will lock the movement of the lifting arms. To unlock

the safety stop pump a little in the opposite direction so that the safety pin (S) can be pulled up again.