Andover Controls EMX34/CK34 Installation Manual - Page 10

Browse online or download pdf Installation Manual for Computer Hardware Andover Controls EMX34/CK34. Andover Controls EMX34/CK34 12 pages. Cardkey interface board

Print Page

Wiring the LEDs to the EMX 34

1. Locate the plastic Molex connector with the four white wires on the back of the Cardkey

reader.

One wire is connected to male pin 4 and one to pin 5, and two wires are connected to

pin 3. Pin numbers 3, 4, and 5 power the LEDs.

2. Obtain a supplementary Cardkey cable, number 913002/A715 style 2095 300V with a

female Molex connector attached.

If you need to wire the female Molex connector, follow the figure below.

Molex Connector Pinouts

Molex Connector

on Cardkey Reader

Note: The EMX 34 pin numbers correspond to the screws on the EMX 34 printed circuit board.

Pins 3, 4, and 5 are the only pins required in the connector. From the extra cable, the

black wire is connected to pin 3, the white wire to pin 4 and the red to pin 5.

3. Plug the Molex connector into the one on the back of the Cardkey reader.

4. Strip the other end of the supplementary Cardkey cable to expose the wires.

5. Strip the ends of the black, white, and red wires.

6. Following the two preceding figures, place the appropriate wires into the correct

terminals and tighten the screws.

Technical Manuals Online! - http://www.tech-man.com

5VDC (pin6)

LED

PWR (pin 5)

RED

LED (pin 4)

GREEN

LED (pin3)

DATA (pin 2)

GND (pin 1)

EMX 34

Cardkey Unit

RED (5 VDC)

Molex pin 3 (LED PWR)

Molex pin 5 (RED LED)

Molex pin 4 (GRN LED)

WHITE (DATA)

BLACK (GND)

SHIELD (GND)

EMX 34 Installation Guide