Compac Industries Master MR40P Installation And Setup Instructions - Page 6

Browse online or download pdf Installation And Setup Instructions for Dispenser Compac Industries Master MR40P. Compac Industries Master MR40P 17 pages.

Print Page

from the air eliminator. Unregulated connection to an above ground tank will cause

pressurisation.

device MUST be used so that the inlet of the pump cannot become pressurised at any time.

approvals.

Comms Dip-switch settings

Standard Pump Comms Setting

6.1

(Dipswitch SW3)

1-ON

2-OFF

3-ON

4-OFF

These are factory set to the standard setting unless ordered otherwise.eg Gilbarco.

Gilbarco Pump comms Setting

6.2

(Special software and interface board required)

1-OFF

2-ON

3-OFF

4-ON

G:\Masters\Installation Sheets\Master & Premier\MR40-80P Installation Sheet.doc

The pump inlet must not be pressurised at any time. This will cause fuel to flow

For above ground tanks a regulator valve such as a Tokheim valve or similar

The air switch is not to be disconnected. Disconnection will void NSC and TMU

Page 6 of 17