Electrolux 42 Owner's Manual And Installation Instructions - Page 10

Browse online or download pdf Owner's Manual And Installation Instructions for Ventilation Hood Electrolux 42. Electrolux 42 45 pages. 30” and 36” free-standing range hood
Also for Electrolux 42: Installation, Use & Care Manual (22 pages)

Electrolux 42 Owner's Manual And Installation Instructions
About the ice and water dispenser and automatic icemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Access Door
Ice Storage Bin
Rotate
Drive
Mechanism
10
Ice Storage Bin
To remove:
Lift up the access door to reach the
icemaker. Set the icemaker power switch
to the O (off) position. With the access
door closed, support the storage bin at
the bottom while slightly lifting. Pull bin
straight out.
To replace:
Slide the bin back until the tab on
the bin locks into the slot on the shelf.
If the bin does not go all the way back,
remove it and rotate the drive mechanism
1/4 turn. Then push the bin back again.
Important facts about your

ice and water dispenser

Do not add ice from trays or bags to the
storage bin. It may not crush or dispense
well.
Avoid overfilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in
the chute to freeze shut. If ice is blocking
the chute, poke it through with a wooden
spoon.

Automatic Icemaker

A newly-installed refrigerator may take 12–24
hours to begin making ice.
The icemaker will produce seven cubes per
cycle—approximately 15 cycles or more in
a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch to O (off).
When the refrigerator has been connected
to the water supply, set the power switch to
I (on). The green light will come on.
Throw away the first full bucket of ice.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the
storage bin may cause the icemaker
or auger to jam.
To keep dispensed ice from missing
the glass, put the glass close to, but not
touching, the dispenser opening.
Some crushed ice may be dispensed
even though you selected Cubed Ice.
This happens occasionally when a few
cubes accidentally get directed to the
crusher.
After crushed ice is dispensed, some
water may drip from the chute.
The first glass of water dispensed may
be warmer than the following ones.
This is normal.
Power
Switch
Icemaker
Green
Power Light
Feeler Arm
If ice is not used frequently, old ice cubes
will become cloudy, taste stale and shrink.
After the icemaker has been turned on
again, there will be a delay of about 45
minutes before the icemaker resumes
operations.
NOTE: In homes with lower-than-average
water pressure, you may hear the icemaker
water valve cycle on several times when
making one batch of ice. Recommended
water pressure is 60 psi.