Andrew DB365-WS Installation Instructions

Browse online or download pdf Installation Instructions for Racks & Stands Andrew DB365-WS. Andrew DB365-WS 2 pages. Wooden pole/wall mount clamp

Print Page

Installation Instructions

Wooden Pole/Wall Mount Clamp

DB365W & DB365-WS

GENERAL INFORMATION

The DB365W mounting clamp is used to mount

omni style antennas or mounting pipes (1 1/4" to

3 1/2" O.D.) to a wooden pole or masonry wall.

Two 5/8" (15.88 mm) diameter mounting holes

will be needed in the mounting structure to

accommodate the DB365W clamp. The diameter

of the pole or the wall thickness must not exceed

10" (254 mm).

The DB365-WS kit is the same as the DB365W,

but does not contain the long bolt (Item 6), or the

nuts (Item 7) and washers (Item 8), The DB365-

WS is to be mounted on the opposing side of a

DB365W.

Do not install near power lines.

Power lines, telephone lines, and

guy wires look the same. Assume

any wire or line can electrocute you.

Figure 1. DB365W Mounting Clamp Parts.

Do not install on a wet or windy day or

when lightning or thunder is in the area.

Do not use metal ladder.

Revision K • January 2010 • Page 1 of 2

HOISTING PROCEDURE

Pre-assemble as much of the mounting

hardware as possible to the antenna while on

the ground. (Carefully, read the installation

instructions before proceeding.) If hoisting the

antenna to the top of the tower or structure,

attach a rope to the mounting hardware at the

bottom of the antenna and then make a slip

knot loop of the rope at the top of the antenna.

The slip knot loop will keep the antenna

vertical when hoisting the antenna. For safety,

an additional rope can be attached to the

bottom of the antenna to be used as a guide

by someone on the ground.

0$; 2 '

0,1 2 '

Wear shoes with rubber soles and heels.

Wear protective clothing including a long-

sleeved shirt and rubber gloves.

Bulletin 095265-000