Electrolux DVK6010BR Instruction Manual - Page 31

Browse online or download pdf Instruction Manual for Ventilation Hood Electrolux DVK6010BR. Electrolux DVK6010BR 36 pages.
Also for Electrolux DVK6010BR: Instruction Manual (36 pages)

Print Page

3.4 - Connecting suction or filter hoods

1 - Connecting suction hoods (air is discharged into the atmosphere)

The hood comes with two air outlets, a plastic cover fitted in the

1 - Connecting suction hoods (air is discharged into the atmosphere)

rear hole and a flange to be fitted according to the solution chosen:

The hood comes with two air outlets, a plastic cover fitted in the

top discharge (fig. 8), rear discharge (fig. 9). In case of installation

rear hole and a flange to be fitted according to the solution chosen:

with rear discharge, fit the plastic cover in the top hole and the

top discharge (fig. 8), rear discharge (fig. 9). In case of installation

flange in the rear hole. Using a pipe Ø 100 o 120 mm, connect the

with rear discharge, fit the plastic cover in the top hole and the

air discharge flange to the external discharge duct. Open the grid

flange in the rear hole. Using a pipe Ø 100 o 120 mm, connect the

panel by pressing inwards on the knobs (fig. 10), check that the lever

air discharge flange to the external discharge duct. Open the grid

(hood with one motor) or the handle (hood with two motors) points

panel by pressing inwards on the knobs (fig. 10), check that the lever

to the ducting mode position (fig. 11), remove the charcoal filter, if

(hood with one motor) or the handle (hood with two motors) points

any, by turning the handle anti-clockwise (see par.3.3 2 part 2°).

to the ducting mode position (fig. 11), remove the charcoal filter, if

Respect warning 2.1

any, by turning the handle anti-clockwise (see par.3.3 2 part 2°).

2 - Connecting filter hoods (air is filtered and recirculated inside the

Respect warning 2.1

room) Open the grid panel, check that the lever (hood with one

2 - Connecting filter hoods (air is filtered and recirculated inside the

motor) or the handle (hood with two motors) points to the filter mode

room) Open the grid panel, check that the lever (hood with one

position (fig. 11), insert the charcoal filter

motor) or the handle (hood with two motors) points to the filter mode

2°).

position (fig. 11), insert the charcoal filter

2°).

3.5 - Electrical connection and working test

1 - The safety measures 2.2, 2.3 and 2.4 of paragraph 2 are to be strictly observed.

2 - Once the electrical connection has been completed, check that the worktop illumination, motor

1 - The safety measures 2.2, 2.3 and 2.4 of paragraph 2 are to be strictly observed.

and speeds work properly.

2 - Once the electrical connection has been completed, check that the worktop illumination, motor

and speeds work properly.

(see par.3.3 2 part