Electrolux E30WV60PPS Installation, Use & Care Manual - Page 9

Browse online or download pdf Installation, Use & Care Manual for Ventilation Hood Electrolux E30WV60PPS. Electrolux E30WV60PPS 12 pages. 30"(76.2 cm) and 36"(91.4 cm) range hood
Also for Electrolux E30WV60PPS: Installation, Use & Care Manual (12 pages)

Print Page

1. Venting Requirements

For recessed bottom cabinet only

If the cabinets have front, side or back trim, make 2

wood shims the width of the trim and attach them to

the cabinet bottom recess on both sides.

Installation to wall

(Horizontal duct– 3

⁄

"x 10" Rectangular)

•

Use the diagram or the hood as a template and

mark the locations on the wall for ductwork,

electrical wiring and keyhole screw slots.

WALL

13-5/6" (30" Hood)

16-13/16" (36" Hood)

6-13/16" (30"Hood)

7" (36" Hood)

1-3/16"

6-1/2" (30" Hood)

permanent

14-3/16" (36" Hood)

mounting hole

Center line

Install framing for hood support

•

If drywall is present, mark the screw hole

locations. Remove the template.

•

Cut away enough drywall to expose 2 vertical

studs at the holes location indicated by the

template. Install two horizontal supports at least

4" x 2" between two wall studs at the bottom and

upper mounting holes installation location.

•

The horizontal support must be flush with the

room side of the studs. Use cleats behind both

sides of the support to secure to wall studs.

•

Reinstall drywall and refinish.

IMPORTANT- Framing must be capable of supporting

100 lbs.

13-5/6" (30" Hood)

16-13/16" (36" Hood)

6-13/16" (30"Hood)

7" (36" Hood)

21/32"

permanent

(30" Model)

mounting hole

(36" Model)

Blower Motor Systems Installation

8-1/2" min. opening for ductwork

Centerline of

Installation

Space

•

Cut holes at marked locations for duct and

electrical wiring.

•

For the vertical duct, cut out

front of the cabinet so you can move the duct

freely when installing the hood.

•

It may also ease installation by cutting the hole

⁄

" instead of 10".

•

Drive a mounting screw (from the hardware

packet) partway into each center of the narrow

neck of the keyhole slots marked on the cabinet

bottom.

•

Fix the wiring conduit to the hood.

•

Slide the hood back against the wall. Tighten the

mounting screws. Be sure the screw heads are in

the narrow neck of the keyhole slot.

•

Connect Ductwork to hood.

View From

Cleats

Rear

1" x6" Min.

Mounting

Support

⁄

" extra toward the