Electrolux E36WV60PPS Installation, Use & Care Manual - Page 5

Browse online or download pdf Installation, Use & Care Manual for Ventilation Hood Electrolux E36WV60PPS. Electrolux E36WV60PPS 12 pages. 30"(76.2 cm) and 36"(91.4 cm) range hood
Also for Electrolux E36WV60PPS: Installation, Use & Care Manual (12 pages)

Print Page

List of Materials

CAUTION!
Remove carton carefully. Wear gloves to protect
against sharp edges.
Parts supplied with unit for the installation
•
Hood canopy assembly with blower.
•
Lamp already installed.
•
Transition (3
⁄
" x 10" rectangular)
1
4
•
Grease filter.
•
Hardware bag with:
•
Use and Care / Installation Manual
•
3- 4x8 screws (to assemble Transition)
•
6- 4,5x13 screws
•
4- 10x50 screws
•
Torx 20 Adapter
Remove the protective film covering the product be-
fore putting into operation.
Tools/Materials required
•
Wire nuts
•
Metal duct length to suit installation
•
⁄
" Romex wire connector
1
2
•
Measuring tape
•
Pliers
•
Gloves
•
Knife
•
Safety glasses
•
Electric drill with
⁄
" and
5
16
•
Spirit level
•
Duct tape
•
Screwdrivers:
•
Phillips (Posidrive) #2
•
Torx # 2
•
Wire cutter/stripper
•
Masking tape
•
Hammer
•
Saw, jigsaw or reciprocating saw
List of materials- Electrical & Installation
⁄
" Bits
3
8

Electrical Requirements

Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and
in conformance with National Electrical Code, ANSI/
NFPA 70 (latest edition), or CSA Standards C22.1-
94, Canadian Electrical Code, Part 1 and C22.2 No.
0-M91 (latest edition) and all local codes and ordi-
nances.
If codes permit and a separate ground wire is used, it
is recommended that a qualified electrician determine
that the ground path is adequate.
A copy of the above code standards can be obtained
from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
•
A 120 volt, 60 Hz., AC only, 15-amp, fused
electrical circuit is required.
•
If the house has aluminum wiring, follow the
procedure below:
1. Connect a section of solid copper wire to the
pigtail leads.
2. Connect the aluminum wiring to the added
section of copper wire using special co
nectors and/or tools designed and UL listed
for joining copper to aluminum.
Follow the electrical connector manufacturer's recom-
mended procedure. Aluminum/copper connection
must conform with local codes and industry accepted
wiring practices.
•
Wire sizes and connections must conform with
the rating of the appliance as specified on the
model/serial rating plate.
The model/serial plate is located behind the filter
on the top wall by the electrical box.
•
Wire sizes must conform to the requirements of
the National Electrical Code, ANSI/NFPA 70 (la
est edition), or CSA Standards C22. 1-94,
Canadian Electrical Code, Part 1 and C22.2
No. 0-M91 (latest edition) and all local codes and
ordinances.
requirements
5