Bosch 2 User Manual And Installation Instructions - Page 39

Browse online or download pdf User Manual And Installation Instructions for Refrigerator Bosch 2. Bosch 2 48 pages. Mini blender
Also for Bosch 2: Quick Installation Manual (16 pages), Manual For Installation And Utilisation (18 pages), Original Instructions Manual (13 pages), Original Instructions Manual (22 pages), Instruction Manual (32 pages), User Manual (28 pages), User Manual And Installation Instructions (16 pages), Instruction Manual (42 pages), Operating Instructions Manual (8 pages), Instruction Manual (8 pages), Instruction Manual (12 pages), Quick Start Manual (2 pages), Quick Start Manual (9 pages), Instruction Manual And Installation Instructions (36 pages), Operating Instructions Manual (26 pages), Quick Reference Manual (2 pages), User Manual And Installation Instructions (24 pages), Instruction Manual (42 pages), Information For Use (28 pages), User Manual (40 pages), User Manual And Installation Instructions (35 pages), User Manual (24 pages)

Print Page
Bosch 2 User Manual And Installation Instructions
Fault
The programme dura-
tion changes during
the wash cycle.
No water is visible in
the drum.
Drum jerks after the
programme starts.
Residual water is
present in the com-
partment
.
Vibrations and move-
ment of the appliance
whilst spinning.
Drum rotates, water
does not flow in.
Heavy foam build-up
High spin speed not
reached.
Cause and troubleshooting
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
Water is below the visible area.
Not a fault – no action required.
▶
Do not add any extra water to the appliance while it
▶
is operating.
This is caused by an internal motor test.
Not a fault – no action required.
▶
Insert in compartment
→ "Cleaning the detergent drawer", Page 30
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 15
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 15
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Load detection is active.
Not a fault – no action required.
▶
Note: The load detection can take up to two minutes.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Troubleshooting en
is blocked.
39