Bosch 8 Series Instructions For Installation And Use Manual - Page 13

Print Page

Bosch 8 Series Instructions For Installation And Use Manual

Warning

Risk of fire!

Grease deposits in the grease filter may catch

fire. The specified safety distances must be

observed in order to prevent an accumulation

of heat. Observe the specifications for your

cooking appliance. If gas and electric hobs

are operated together, the largest specified

distance applies.

Only one side of the appliance may be

installed directly next to a high-sided unit or a

wall. The distance between the appliance and

wall or high-sided unit must be at least 50

mm.

Warning

Risk of injury!

Components inside the appliance may have

■

sharp edges. Wear protective gloves.

The appliance may fall down if it has not

Risk of injury!

■

been properly fastened in place. All

fastening components must be fixed firmly

and securely.

The appliance is heavy. To move the

Risk of injury!

■

appliance, 2 people are required. Use only

suitable tools and equipment.

Warning

Risk of electric shock!

Components inside the appliance may have

sharp edges. These may damage the

connecting cable. Do not kink or pinch the

connecting cable during installation.

Warning

Risk of electric shock!

It must always be possible to disconnect the

appliance from the electricity supply. The

appliance must only be connected to a

protective contact socket which has been

correctly installed. If the plug is no longer

accessible following installation of the

appliance, or a fixed connection is required,

an all-pole isolating switch must be present on

the installation side with a contact gap of at

least 3 mm. The fixed connection must only be

installed by an electrician.

Warning

Danger of suffocation!

Packaging material is dangerous to children.

Never allow children to play with packaging

material.

KGeneral information

Exhaust air mode

i o n

G e n e r a l i n f o r m a t

Warning

Risk of death!

Risk of poisoning from flue gases that are drawn back

in. The exhaust air must not be conveyed into a

functioning smoke or exhaust gas flue or into a shaft

which is used to ventilate installation rooms that contain

heating appliances. If the exhaust air is to be conveyed

into a non-functioning smoke or exhaust gas flue, you

must obtain the consent of the heating engineer

responsible.

If the exhaust air is conveyed through the outer wall, a

telescopic wall box should be used.

Exhaust duct

The appliance manufacturer does not provide any

Note:

warranty for faults attributable to the pipe section.

The appliance achieves its optimum performance by

■

means of a short, straight exhaust air pipe and as

large a pipe diameter as possible.

As a result of long, rough exhaust air pipes, many

■

pipe bends or pipe diameters that are smaller than

150 mm, the optimum extraction performance is not

achieved and fan noise is increased.

The pipes or hoses for laying the exhaust air line

■

must consist of non-combustible material.

Round pipes

An inner diameter of 150 mm, but at least 120 mm, is

recommended.

Flat ducts

The inner cross-section must correspond to the

diameter of the round pipes.

150 mm diameter, approx. 177 cm

120 mm diameter, approx. 113 cm

Flat ducts should not have any sharp deflections.

■

Use sealing strips for different pipe diameters.

■

General information en