Bosch 8 Series Instructions For Installation And Use Manual - Page 6

Print Page

Bosch 8 Series Instructions For Installation And Use Manual

Operating the appliance

1Operating the appliance

These instructions apply to several appliance variants. It

p l i a n c e

O p e r a t i n g t h e a p

is possible that individual features are described which

do not apply to your appliance.

Control panel model 1

Explanation

Fan on/off

1-3

Fan settings

Intensive setting 1

Intensive setting 2

Fan run-on

Metal grease filter saturation indicator

Light on/off/dimming

Setting the fan

Switching on

Pull out the filter pull-out and touch the

■

The fan will start at setting 2.

Select the fan settings.

■

When the filter pull-out is pushed in, only fan

Note:

settings 1, 2 and 3 can be selected.

Switching off

Touch the

symbol. Slide in the filter pull-out.

Intensive setting

You can use the intensive setting if there is a large

build-up of odours and fumes/vapours.

Touch the

After approximately six minutes, the electronics

automatically reduce the fan to a lower setting . If you

want to end the intensive setting before the preset time

expires, touch the symbol for the required fan setting.

Fan run-on time

Touch the

symbol or slide in the filter pull-out while

the extractor hood is operating.

After approximately 10 minutes, the fan will switch off

automatically.

symbol.

Switch on the extractor hood when you start

Note:

cooking and switch it off again several minutes after you

have finished cooking. This is the most effective way of

removing the kitchen fumes.

Saturation display

When the metal grease filters are saturated, an audible

signal sounds for approximately four seconds after the

fan is switched off.

The indicator above the

If you have not yet done so, the metal grease filters

should now be cleaned.

For instructions on how to clean the metal grease filters,

please refer to the section:

The saturation indicator can be reset while it is flashing.

To do this, touch the

Lighting

The lighting can be switched on and off independently

of the fan.

Touch the

symbol.

Setting the brightness

Press and hold the

symbol until the required

brightness is reached.

Audible signal

Switching on the audible signal

Touch and hold the

same time for approximately three seconds when the

fan is switched off. An audible signal sounds as an

acknowledgement.

Switching off the acoustic signal

Repeat the "Switching on the acoustic signal" process.

symbol flashes as well.

Cleaning and maintenance

symbol.

and

symbols at the