Daikin 2MXU50GV1B Installation Manual - Page 4

Browse online or download pdf Installation Manual for Heat Pump Daikin 2MXU50GV1B. Daikin 2MXU50GV1B 18 pages. Outdoor unit r410a split series

Print Page

Accessories

Accessories supplied with the outdoor unit:

Installation Manual

There is on the bottom packing case.

Reducer assy (Only 50 class)

The reducer assy is attached to the

stop valve mounting plate inside the

stop valve cover.

CAUTION

Remove the reducer assy from the

stop valve mounting plate before

installing the outdoor unit regardless

of whether the assy has been used.

Precautions for Selecting the Location

1) Choose a place solid enough to bear the weight and vibration of the unit, where the operation noise will not be amplified.

2) Choose a location where the hot air discharged from the unit or the operation noise, will not cause a nuisance to the

neighbors of the user.

3) Avoid places near a bedroom and the like, so that the operation noise will cause no trouble.

4) There must be sufficient spaces for carrying the unit into and out of the site.

5) There must be sufficient space for air passage and no obstructions around the air inlet and the air outlet.

6) The site must be free from the possibility of flammable gas leakage in a nearby place.

Locate the unit so that the noise and the discharged hot air will not annoy the neighbors.

7) Install units, power cords and inter-unit cables at least 3m away from television and radio sets. This is to prevent inter-

ference to images and sounds. (Noises may be heard even if they are more than 3m away depending on radio wave

conditions.)

8) In coastal areas or other places with salty atmosphere of sulfate gas, corrosion may shorten the life of the air conditioner.

9) Since drain flows out of the outdoor unit, do not place under the unit anything which must be kept away from moisture.

NOTE:

Cannot be installed hanging from ceiling or stacked.

CAUTION

When operating the air conditioner in a low outdoor ambient tempera-

ture, be sure to follow the instructions described below.

1) To prevent exposure to wind, install the outdoor unit with its suction

side facing the wall.

2) Never install the outdoor unit at a site where the suction side may

be exposed directly to wind.

3) To prevent exposure to wind, it is recommended to install a baffle

plate on the air discharge side of the outdoor unit.

4) In heavy snowfall areas, select an installation site where the snow

will not affect the unit.

■English

Refrigerant charge label

There is on the bottom packing case.

Screw bag

(For fixing the wire retainer and

humidifying hose cover)

There is on the bottom packing case.

Multilingual fluorinated

greenhouse gases label

There is on the bottom packing case.

Drain plug

There is on the bottom packing case.

Humidifying hose cover

Construct a large canopy.

Construct a pedestal.

Install the unit high enough off the

ground to prevent burying in snow.