Bosch B26FT series Operating And Installation Instructions - Page 17

Browse online or download pdf Operating And Installation Instructions for Refrigerator Bosch B26FT series. Bosch B26FT series 32 pages.

Print Page

Super freezing

Food should be frozen as quickly as possible in order
to retain their vitamins, nutritional value, appearance
and flavor.
To prevent an undesirable rise in temperature when
placing fresh food in the freezer compartment, switch
on super freezing several hours beforehand.
As a rule, 4 to 6 hours is adequate. Allow for a
minimum of 24 hours if planning to use the maximum
freezing capacity.
Smaller quantities of food can be frozen without super
freezing.
To switch on super freezing:
Press "freezer" until "super" appears on the left on the
display panel.
To switch off super freezing:
Press "freezer".
The word "super" disappears on the display panel.
The temperature is automatically set to the previous
setting temperature.
NOTICE
Super freezing switches off automatically after
approximately 2 days.

Quick ice

Use this function to accelerate the production of ice
cubes temporarly.
To switch on quick ice:
Press "super/quick ice".
The "quick ice" symbol appears on the display panel.
When the ice cube container is full, quick ice
automatically shuts off after a few hours.
NOTICE
When quick ice is activated, the power of the
appliance is increased temporarily. This increases its
energy consumption.

Water filter symbol

The symbol indicates the filter cartridge's period of
use.
Up to two months.
Up to four months.
Up to six months.
After six months, the symbol flashes.
Replace the filter cartridge.
When the appliance is turned off, the water filter
symbol is reset.
To reset the water filter symbol after replacing the
filter cartridge:
Press and hold the "light/filter" button for 3 seconds.
The symbol stops flashing.

Temperature unit

The temperature can be displayed in degrees
Fahrenheit (°F) or Celsius (°C).
After the appliance is switched on, the temperature
appears in degrees Fahrenheit (°F).
To set the temperature unit:
Press "alarm/lock" for 2 seconds.
The "panel lock" symbol appears.
en-us
17