Atlantic Technology 224 SB Instruction Manual - Page 5
Browse online or download pdf Instruction Manual for Subwoofer Atlantic Technology 224 SB. Atlantic Technology 224 SB 12 pages. High performance powered subwoofers
Print Page
100
NORMAL
ON
160
Instruction Manual
INVERT
AUTO
Connecting Your Subwoofer
Use the low-level (RCA jack) subwoofer line out of your surround sound
receiver/processor. Simply connect your subwoofer with a high quality
shielded cable as shown in the diagram on page 7. Please consult your
processor/receiver manual for further information.
WARNING: To prevent risk of electrical shock or damage to your
equipment, always unplug all component AC cords before pro-
ceeding with speaker and component connections! The last step in
wiring your system should be plugging in the AC cords!
Subwoofer Line Out to Low Level In
Run an RCA cable from your receiver's Sub Out jack to the L/Mono input
jack on the back of the subwoofer (Figure 3). If your receiver/processor
has stereo subwoofer outputs, connect these to both the L/Mono and R
jacks on the back of the subwoofer (Figure 4).
Using the Low Level Output
If desired, you can run a low level signal through the subwoofer and out
110-120V
220-240V
to another unit. This way you can add an additional subwoofer with mini-
mal additional wiring. The signal that comes out of the output jacks is
identical to the input signal.
ON
OFF
Power Connection
AC INPUT
50-60Hz 300W MAX
FOR 110-120VAC, USE 2.5AL 250V FUSE
FOR 220-240VAC, USE 1.25AL 250V FUSE
of an amplifier, preamplifier, or receiver. The power demands of the sub-
woofer amplifier may exceed the power rating of the switched outlet and
may damage the equipment.
Connect the power cord to an AC outlet
only after making all other connections
to the subwoofer. This will avoid any
chance of accidentally activating the
subwoofer while wiring. Atlantic Tech-
nology does not recommend plugging
the subwoofer into the switched outlet
Figure 2
AC Connection
Your subwoofer is totally automatic in its operation. The automatic on/
off circuitry will only activate the subwoofer in the presence of an audio
signal from your system. After 7-10 minutes with no signal detected from
the rest of the system, the amplifier will shut itself off and go back into
standby mode. When the sub is in operating mode, the status LED will
glow green. The LED will glow amber in the Standby mode and power
consumption in this mode is negligible. Standby operation can be com-
pletely bypassed by placing the standby switch on the rear panel to the
ON position.
Connecting Your Subwoofer
5