Electrolux ICON E40PV100FS Installation Manual - Page 4
Browse online or download pdf Installation Manual for Ventilation Hood Electrolux ICON E40PV100FS. Electrolux ICON E40PV100FS 9 pages. Electrolux vent hood e40pv100fs
Also for Electrolux ICON E40PV100FS: Use & Care Manual Installation Instructions (24 pages)
Print Page
Installation
INSTALLING THE SUPPORT SYSTEM
1 At hood location, install 2 x 4 cross framing between ceiling joists
using dimensions shown in Figure 6.
2 Finish the ceiling surface. Be sure to mark the location of the
ceiling joists and cross framing.
3 Measure the ceiling height and determine distance between the cook
top and bottom of hood.
4 Per the chart, adjust overall length of the support frame as shown in
Figure 7. Remove and reinstall (4) screws in the height adjustment
slots to achieve proper length. Install (4) additional 3.9 x 9.5mm
screws and 4.5 diameter washers from the Hardware Parts Bag.
SUPPORT FRAME HEIGHT ADJUSTMENT CHART
HOOD DISTANCE ABOVE 36" HIGH COOKTOP (SEE NOTE A)
CEILING
HEIGHT
24"
25"
25"
24"
8-FEET
9-FEET
10-FEET
(See note B)
NOTE
A. Minimum hood distance above the cook top must not be less than 24".
A maximum of 30" above the cook top is highly recommended for best
capture of cooking impurities.
Distances over 30" above the cook top are at the installer's and user's
discretion - providing that the ceiling height and flue length permit.
B. Requires optional 10-foot flue extension model EXPV100S.
5 Secure the support frame to ceiling joists and cross framing with
(4) 6 x 70mm lag bolts and 6.4 diameter washers provided. Make
sure the bolts are driven into centers of joists and cross framing for
maximum strength. See Figure 8.
6 Run 2-wire plus ground electrical cable through the hole on top of
the support frame bracket. Cable length must extend at least 12"
below the bottom of the support frame. Secure cable to the support
frame with an appropriate cable connector.
26"
27"
28"
29"
SUPPORT FRAME LENGTH
23"
46"
45"
44"
30"
31"
43"
9-13/16"
WASHER
MOUNTING
(6 x 70mm)
TOP VIEW OF SUPPORT FRAME
9-13/16"
Figure 6
WASHERS
4.5 DIA (8)
Figure 7
DRYWALL
CROSS
FRAMING
CEILING
SCREWS
FRONT
HEIGHT
ADJUSTMENT
SUPPORT
FRAME
Figure 8
7-13/16"
SCREWS
3.9 X
9.5mm (8)
JOISTS
SLOTS